|
Big Block Talk! Everything about swapping a big block engine into your cart! |
|
Thread Tools | Display Modes |
03-18-2011, 10:28 PM | #1 |
Not Yet Wild
Join Date: Mar 2011
Location: baltimore md
Posts: 25
|
clutch spacing
i am useing a 50 1/4" belt with a stock e z go rear and a cv 06 1" shaft front clutch. does anybody know what the shaft to shaft measurement is? i don't want to drill a bunch of holes when i mount my big block motor. it looks to be about 13" but i'm not sure.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-18-2011, 11:41 PM | #2 |
Raised by coyotes
Join Date: Nov 2008
Location: Central Texas
Posts: 5,658
|
Re: clutch spacing
The OD of both clutches can vary, so there is no "typical" or stock measurement. The belt you are using is on the long side of stock measurements. Most fabricators try to get a measurement that "fits" a readily available belt length so you only need to slot motor mounts a little bit. The standard "ScottyB" method is to use a string or cloth measuring tape and measure around the center shaft of the drive clutch and the outside edge "circumference" of the driven clutch, and add two inches. This is the belt length you need to use.......
|
03-19-2011, 04:26 AM | #3 |
Not Yet Wild
Join Date: Mar 2011
Location: baltimore md
Posts: 25
|
Re: clutch spacing
thanks i can figure it from that.
|
03-19-2011, 04:55 AM | #4 |
Raised by coyotes
Join Date: Nov 2008
Location: Central Texas
Posts: 5,658
|
Re: clutch spacing
There are lots of belts out there. I run a snow mobile belt, 1/16" wider that stock. It's 45 13/32 OD. I find them on EBay cheap from time to time and have bought spares. I put together a spreadsheet of all the Dayco/ Carlisle snow mobile/ ATV belts by length / width a while back. Most are in the 45-47" range. Let me know if you need a copy......
|
03-19-2011, 03:33 PM | #5 |
Not Yet Wild
Join Date: Mar 2011
Location: baltimore md
Posts: 25
|
Re: clutch spacing
i might but i already bought the 50 1/4" one.so if i make a string 48 1/4" that should be were i mount the engine.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Tips & Hints for installing Clutch Tuning Kit, Removal of Drive Clutch | Gas Club Car | |||
2004 txt electric wheel stud spacing... | Electric EZGO | |||
lug nut spacing?? EZgo | Gas EZGO |