|
Big Block Talk! Everything about swapping a big block engine into your cart! |
|
Thread Tools | Display Modes |
02-09-2007, 03:10 PM | #1 |
Gone Wild
Join Date: Feb 2007
Posts: 229
|
Machining CC Clutch to 1in with 1/4 keyway
Has anyone machined a CC clutch to fit 1in shaft w/keyway. I know the clutch is tappered but can this be done
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-09-2007, 03:19 PM | #2 |
Gone Wild
Join Date: Jan 2007
Posts: 207
|
I had mine done for my ezgo!
|
02-09-2007, 05:05 PM | #3 | |
Gone Wild
Join Date: Dec 2006
Location: ComplainAboutNoNo'sProfile-Ville
Posts: 4,995
|
Re: Machining CC Clutch to 1in with 1/4 keyway
Quote:
|
|
02-09-2007, 05:11 PM | #4 |
Gone Wild
Join Date: Jan 2007
Posts: 731
|
doesn't cc use a tapered shaft??
C'mon NO NO! You should know better! |
02-09-2007, 05:13 PM | #5 | |
Gone Wild
Join Date: Dec 2006
Location: ComplainAboutNoNo'sProfile-Ville
Posts: 4,995
|
Quote:
Yes, Club Cars use a tapered shaft. I might order a clutch from ol Chinky McNoodle too. |
|
02-09-2007, 05:17 PM | #6 |
Gone Wild
Join Date: Jan 2007
Posts: 731
|
Careful! He might have taken a bite out of the clutches too!
|
02-09-2007, 05:23 PM | #7 |
Gone Wild
Join Date: Feb 2007
Posts: 229
|
I don't know if I am right but the shaft is 30mm with a 1:10 taper which is 1/8 bigger than a 1in shaft
|
02-09-2007, 05:36 PM | #8 | |
Gone Wild
Join Date: Dec 2006
Location: ComplainAboutNoNo'sProfile-Ville
Posts: 4,995
|
Quote:
|
|
02-09-2007, 06:27 PM | #9 |
Gone Wild
Join Date: Jan 2007
Posts: 731
|
I think its a great excuse to get a new, nice, big clutch. Easier too. It will just cost more.
|
02-09-2007, 06:28 PM | #10 | |
Gone Wild
Join Date: Dec 2006
Location: ComplainAboutNoNo'sProfile-Ville
Posts: 4,995
|
Quote:
|
|