|
Big Block Talk! Everything about swapping a big block engine into your cart! |
|
Thread Tools | Display Modes |
07-06-2011, 08:54 AM | #1 |
Gone Wild
Join Date: Oct 2010
Location: Central New York
Posts: 812
|
16 HP Vanguard shut off problem
Ok please be as clear as possible to get through my sometimes thick skull. Right now I have a Briggs and Stratton keyed ignition. I wired it up per the diagrams on the site, 16 amp regulator 490066 diagram under the big block site vanguard wiring diagrams. I use the key to start it and shut it off. A little inconvienent. The only way I can get it to stop is to turn the ignition off which takes about 3 seconds because I am shutting off the power to the gas solonoid to the carb, right? I have the small black wire coming from what I think is one of the coils, tried grounding that when the engine was running and nothing happens. I would like to use the pedal micro switch to ground something out or shut power off to something so it would immediately shut the engine off. Can one of you wizards show me how to do this? I plan on putting the old starter generator back on at some point but not right now.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-06-2011, 10:34 AM | #2 |
Raised by coyotes
Join Date: Nov 2008
Location: Central Texas
Posts: 5,658
|
Re: 16 HP Vanguard shut off problem
Need to know if you have a 5 pole or 6 pole switch........
|
07-06-2011, 05:24 PM | #3 |
Gone Wild
Join Date: Oct 2010
Location: Central New York
Posts: 812
|
Re: 16 HP Vanguard shut off problem
6 pole
|
07-06-2011, 07:53 PM | #4 |
Raised by coyotes
Join Date: Nov 2008
Location: Central Texas
Posts: 5,658
|
Re: 16 HP Vanguard shut off problem
Have you checked the stickie in the BB section?
http://www.buggiesgonewild.com/big-b...rd-wiring.html The key switch needs to be grounded if it's mounted to the plastic body, that's terminal 1. The stop switch (terminal3) should be a small spade connection on the front of the side engine shroud. Other than that, engine itself needs to be grounded and the terminals on the starter can't touch the frame or she won't turn off. That's about all I can think of........ |
07-07-2011, 06:21 AM | #5 |
Gone Wild
Join Date: Oct 2010
Location: Central New York
Posts: 812
|
Re: 16 HP Vanguard shut off problem
Thanks again. Actually I put a heavier return spring on the throttle linkage and now it idles itself so low I can shift it while running and it turns off if let it idle for a few seconds. Very controllable now. I think my ignition switch needs the ground put on spade one also.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Cured my Vanguard starter problem | Big Block Talk! | |||
vanguard briggs 18hp idle problem | Big Block Talk! | |||
18hp Vanguard cam/starter problem | Big Block Talk! | |||
Vanguard motor doesn't shut off quickly | Big Block Talk! | |||
23hp Vanguard carb fuel shut off solenoid sticking | Big Block Talk! |