crankshaft to pressure plate adaptor for cushman w/briggs&stratt

countryboy42148

I have a cushman truckster; i am putting a 16hp b&s vanguard in. The omc engine had a 1 1/4 " crankshaft; the b&s has a 1" shaft. I am useing the old clutch and transmission. I need a crankshaft to pressure plate adaptor. I have the 1 1/4 bore adaptor, looking for a 1" bore adapter. Any ideas where to look?

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

oojepxj

i an new here but i made one out of .187 steel plate and sleved the hub for flywheel to fit new shaft mine was a honda gx670 swap it ran aswome good luck

DustyWolfe

exactly what i would do and lets you retain the keyway without mods

countryboy42148

Thank You both for your reply. I have a bushing to adapt it, but wanted an adaptor that didn't require it.

sho305

If its not complex you could look for a machinist to do it, maybe someone with the stuff at home or access at work, etc. I mean have them make you a new one. Only hard part is a keyway you would have to broach usually and they might not have one.