Sprocket sizes with a Tav 2 ?

MobileMarine

OK , I just picked up a 212 predator and a genuine comet tav2 12tooth converter system for 120.00 ! DEAL DEAL ! What size sprocket are you guys using on the axle side with this set up ? #35 chain '' small I know'' and the cart is a 94' club car .
Chain and reliable throttle system is all I am waiting to finish to hit the rd on this thing , everything is mounted and running .
I also picked up a Briggs 16hp v-twin but since my current set up is all 3/4 Im going to hold off on that swap till I get bored with this one

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

1moretoy

I have the same enging and TAV2 but since mine doesn't line up with the rear sprocket I had to use a jackshaft. Discounting the extra sprockets I used, you should be fine with a 20 or 25 tooth on the rear since the axle is geared also. (I have the 20 on mine right now) 25 had lots of low end torque but slowed it down at top speed.

MobileMarine

Just wasted 50.00 on some high end 2 piece sprockets and hubs , 60 , 64 and 70 tooth . I started with the 60 and it barely move , no jack shaft on mine , i just re drilled and moved the whole engine over . Local store has not one #35 sprockets ! Where is a junk 20 speed bicycle when you need it ?
What a pain in the *** this has been

1moretoy

I bought some at tractor supply the others I ordered on line

1moretoy

If it weren't for the gear ratio in the transaxle you would need the big gear to get it moving. I feel your pain cause I have been playing with different gears for some time now and just got mine right.

MobileMarine

I think i have a 12 tooth but im afraid thats going to be too small , it would be kick arse but not enough power to turn it , Ill get something Obama rigged soon