SV650-s Engine swa

RenoHuskerDu · 09-20-2018, 09:36 AM

I have a club car carryall 272 anf I would like to engine swap it for a motorcycle engine. I've found a seller with:
- engine/transmission: compression tested to be 200 and 205 psi front and rear.
- throttle body
- throttle position sensor
- fuel pump assembly
- air intake box
- gas tank
- 2 brothers exhaust
- radiator (has a small leak somewhere)
- radiator hoses
- dash tachometer

Could someone who has done this type of modification to their cart give me advice? I'm a beginner at golf carts and all input is welcomed. My biggest concern is will the stock axle be good enough.

Rooster59 · 09-20-2018, 02:32 PM

That engine is pretty long and tall. Plus you need air flow for the radiator. Better take some measurements before you make a commitment. Plus you will need some fore/aft room for a jackshaft (?) to connect the chain drive. Looks like a pretty sizable job. Good luck.

Unforgiven · 09-20-2018, 05:14 PM

Does that model bike have reverse? Is the cart a gas or electric?

There is a build in this section of that build. Was a cool project.

RenoHuskerDu · 09-20-2018, 10:02 PM

Quote:

Originally Posted by Unforgiven

Does that model bike have reverse? Is the cart a gas or electric?

There is a build in this section of that build. Was a cool project.

The motorcycle does not have a reverse gear, that is very uncommon on bikes. The cart is a gasser. Could you link me that build?

Unforgiven · 09-21-2018, 08:32 AM

Member: Tbirder
http://www.buggiesgonewild.com/bike-...carry-all.html

In my opinion one of the coolest builds on BGW. Lots of picture and videos. I've seen a few larger cycles with reverse.

Since its a gaser, have you thought about a Big block swap?

09-20-2018, 09:36 AM	#1
RenoHuskerDu Getting Wild Join Date: Jul 2018 Location: Central Texas Posts: 107	SV650-s Engine swa I have a club car carryall 272 anf I would like to engine swap it for a motorcycle engine. I've found a seller with: - engine/transmission: compression tested to be 200 and 205 psi front and rear. - throttle body - throttle position sensor - fuel pump assembly - air intake box - gas tank - 2 brothers exhaust - radiator (has a small leak somewhere) - radiator hoses - dash tachometer Could someone who has done this type of modification to their cart give me advice? I'm a beginner at golf carts and all input is welcomed. My biggest concern is will the stock axle be good enough.

09-20-2018, 02:32 PM	#2
Rooster59 Gone Wild Join Date: Jul 2017 Location: East Central Missouri Posts: 1,955	Re: SV650-s Engine swa That engine is pretty long and tall. Plus you need air flow for the radiator. Better take some measurements before you make a commitment. Plus you will need some fore/aft room for a jackshaft (?) to connect the chain drive. Looks like a pretty sizable job. Good luck.

09-20-2018, 05:14 PM	#3
Unforgiven Feral Join Date: Feb 2011 Location: Central Miss Posts: 1,931	Re: SV650-s Engine swa Does that model bike have reverse? Is the cart a gas or electric? There is a build in this section of that build. Was a cool project.

09-21-2018, 08:32 AM	#5
Unforgiven Feral Join Date: Feb 2011 Location: Central Miss Posts: 1,931	Re: SV650-s Engine swa Member: Tbirder http://www.buggiesgonewild.com/bike-...carry-all.html In my opinion one of the coolest builds on BGW. Lots of picture and videos. I've seen a few larger cycles with reverse. Since its a gaser, have you thought about a Big block swap?

Similar Threads
Thread	Forum
1984 ezgo marathon engine replacement to atv engine	Gas EZGO
2007 st 350 blown engine, rebuild or new Predator engine?	Gas EZGO
Engine and Wireing Diagram Robin Engine Model # EC253PG	Gas EZGO
Engine blues...update on my engine knock	Gas Yamaha
Amsoil Synthetic engine oil or Royal Purple engine oil	Big Block Talk!

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum