05-03-2015, 05:00 PM | #1 |
Not Yet Wild
Join Date: Nov 2011
Posts: 16
|
G2 kill switch wire?
I'm putting the Harbor Freight 440 in my G2 and have been reading up, but can't find what I need. I want to use the stock starter/gen and pedal start. Right now I have it so you turn the key to the motor on or off. What wire from the cart or pedal to I hook up to the motor so it shuts down when I let off the pedal?
I know the motor shuts off when you ground the wire to the coil, I'm just looking for what to hook it to. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-03-2015, 06:41 PM | #2 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,445
|
Re: G2 kill switch wire?
You need this!
http://www.buggiesgonewild.com/clone...g-diagram.html Relay and harness/plug were $3 each on amazon when I put this on mine. Works just like stock, always shuts off. You can pull the relay to recoil start in emergency and it will run and not shut off. I left the stock kill switch on my engine, though I never used it. |
05-04-2015, 07:32 AM | #3 |
Not Yet Wild
Join Date: Nov 2011
Posts: 16
|
Re: G2 kill switch wire?
Thanks
|
05-04-2015, 04:55 PM | #4 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,445
|
Re: G2 kill switch wire?
You would leave your key (or kill switch) on. The relay will kill it any time the pedal is not down to run, even if the cart is off it is killed. I was pretty worried about throttle sticking and you have no way to shut it down other than choking it.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
88 CC DS Clone swap: the kill wire | Clone Engine Swaps | |||
Want to install a Tow Switch/Kill Switch | Design Center | |||
Briggs Vanguard coil kill wire question | Big Block Talk! | |||
Key switch & Kill switch question | Gas Club Car | |||
Where is the engine kill wire on the FE280 motor? | Gas Club Car |