03-25-2016, 07:47 AM | #1 |
Not Yet Wild
Join Date: Aug 2011
Location: NW Mississippi
Posts: 28
|
Wiring
Getting close to finish and taking my first ride. But I need some wiring advice. First I searched & didn't come up with much.
When I started the clone project I marked the headlight & tail light wires. I plan on mounting the electric start switch that came with the 18hp Duramax on the dash some where. That will be simple for me by just extending the factory wires. Now I need some advice or a simple diagram of where to connect the headlight & tail light wires. I also plan to use the stock on/off key switch that comes on a stock CC for a kill switch if that is possible ? Diagram needed for that also. AS ALWAYS THANKS. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-25-2016, 04:16 PM | #2 |
Not Yet Wild
Join Date: Dec 2015
Location: Park City, Ky
Posts: 34
|
Re: Wiring
I just did the same with my 90 model ds and a duomax motor. the wiring for the club car can be found here. as for the duomax there was a schematic includrd with the paperwork that came with the engine. hope this helps
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Controller wiring/DCS fnr switch wiring | Electric EZGO | |||
wiring ez-go | Electric EZGO | |||
Wiring lights and a winch? Use a converter or hard wiring? | Electric EZGO | |||
Wiring lights and a winch? Use a converter or hard wiring? | Electric EZGO | |||
So what's the best way... Wiring | Electric Club Car |