|
12-15-2019, 09:42 PM
|
#1 |
|
Not Yet Wild
Join Date: Feb 2014
Posts: 10
|
1996 club car clone swap ignition box question
I have a 96 club car that had the FX 290 that I just removed. I'm putting in the harbor freight 63940 Clone Engine and want to know what I need to do with this ignition box? The cart already has a key switch on the dash and I'd like to retain that. Has anyone tackled this before?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
12-24-2019, 12:47 PM
|
#2 |
|
Not Yet Wild
Join Date: Aug 2016
Posts: 45
|
Re: 1996 club car clone swap ignition box question
Couple of things to know, if you want to use the stock charge coil (it's only 3amps, not very good) there is a diode in that box, without a diode the charge coil will be burned out almost instantly. Also, the ignition wire is grounded to kill the engine, and needs nothing for the engine to run. I don't know how the ignition switch is setup on your cart.
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| club car clone swap | Clone Engine Swaps | |||
| club car clone swap - clutch question | Clone Engine Swaps | |||
| Clone swap with 5 pin relay solenoid question | Clone Engine Swaps | |||
| 97 club car clone swap | Clone Engine Swaps | |||
| Club Car Clone swap | Clone Engine Swaps | |||
Linear Mode
