|
08-23-2011, 08:49 PM
|
#1 |
|
Not Yet Wild
Join Date: Jun 2011
Posts: 44
|
Clone allignment
I'm build a g2. I've got another thread started on the build but want to ask a generic question that I think should be the same for any cart.
How to I make sure my clone is aligned correctly with the rear end? I had it where I thought was right. Then I looked at my stock cart. When I hit the gas, it looked like the belt might have moved towards the engine a small amount when the rear cluth opened up. Thanks for any insight. There I a wealth in knowledge on the forum. I hope I can add to it with my limited knowledge. |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Another Clone Swap | Clone Engine Swaps | |||
| E-Z-Go Rear Wheel Allignment | Gas EZGO | |||
| 13 clone | Clone Engine Swaps | |||
| Clone vs. Vanguard | Clone Engine Swaps | |||
| Front Wheel Allignment | Gas Club Car | |||
Linear Mode
