relay wiring to kill clone

aquadreamin

I have been doing some research on how to wire a predator 420cc clone in my yamaha g9. There are several post on using a 5 pin relay to act as a kill switch when you let off the stock gas pedal. Unfortunately I still don't quite understand. My clone has the electric start and magnet that I think makes the plug fire. Can someone please walk me through this.

Thanks Tom

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

Black Thunder

I did mine like sho305 did. It works great.
Go thru his 1st build and you will find it. If you cant I will look at mine and let you know how its wired.

sho305

Clone has a magneto ignition like most B&S are, it powers itself. To stop it you ground the wire or on old ones ground the plug wire. The kill switch, low oil sensor, and key all ground that wire from the coil to kill it. So you get a relay and wire it to be grounded all the time on the output side of the relay. Then hook the 12v from your pedal to the relay and ground it to battery. That way its killed all the time, the relay disconnects it from ground when you step on the pedal. If you ever need to pull start it or something you can pull the relay out of the plug (if you buy the plug for it that has all the wires in it and much easier to hook up) and it will run. I also left the kill switch on mine for that reason, its a recoil engine. The details are in my first build about clones in yamaha section, may also be in my second clone thread here in clones section. The relay and the plugs are on amazon for $4 each or something.