09-10-2013, 09:48 AM | #1 |
Not Yet Wild
Join Date: Sep 2013
Location: Kansas City
Posts: 11
|
What Taper on Stock ClubCar clutch (Specs for clone engine)
Anyone know what the stock taper is on the FE290-400 clockwise rotation club car clutches are? I am looking at a couple of options and the manufacturer has tapered shaft engines and straight shaft engines - Ideally it would be able to have the stock clutch bolt right up to it so I have to match taper and length, etc.
Ideally if someone knows of a drawing of the stock kawasaki shaft on the club car engines similar to the one attached it would really help me out! OK - found this on line after searching for hours and finally found the reference - can anyone validate that the tapered shaft referenced in the FE350 Data Sheet is the one used on the CC clutches? http://www.manualslib.com/manual/375...50.html?page=2 |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-10-2013, 11:19 AM | #2 |
Gone Wild
Join Date: Sep 2011
Location: ARIZONA
Posts: 476
|
Re: What Taper on Stock ClubCar clutch (Specs for clone engine)
Stock CC use what is called a 30mm 1:10 taper. Most all carts do.
The one pictured is for a different application |
09-10-2013, 12:48 PM | #3 |
Not Yet Wild
Join Date: May 2013
Posts: 23
|
Re: What Taper on Stock ClubCar clutch (Specs for clone engine)
You can just purchase the adapter from CPP and use your factory clutch on a 1" straight shaft
|
09-10-2013, 08:39 PM | #4 |
Gone Wild
Join Date: Jun 2012
Location: Las Vegas, NV
Posts: 961
|
Re: What Taper on Stock ClubCar clutch (Specs for clone engine)
The shaft in that picture isnt even close to what youd need. Youll need a 1:10 x 30mm as was said above.
|
09-12-2013, 02:01 AM | #5 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,445
|
Re: What Taper on Stock ClubCar clutch (Specs for clone engine)
I put a CPP adapter on my clone for my yamaha clutch, worked great. Or you can buy a new aftermarket 1" clutch for a 1" shaft engine (typical standard for lawn engines). The adapter fits a 1" and converts it to a taper. There are few lawn engines with that taper if any but I have heard of a few, the small part of the taper is around 1".
|
|
|
Similar Threads | ||||
Thread | Forum | |||
The CLONE engine setup & specs thread | Gas Yamaha | |||
Clone engine specs | Clone Engine Swaps | |||
gx390 taper, fit stock CC clutch? | Big Block Talk! | |||
88 stock clutch going on a 16hp clone | Big Block Talk! | |||
Honda clone with stock clutch on a CC | Big Block Talk! |