I'm BACK got some questions for ya guys

dirtyyoda77

Hey guys glad to be back on the forum I sold my old cart and have regretted it ever since but I guess it just means I get to do something different now

Well I'm picking up a new cart next Saturday and it is in need of some work now. The guy I bought it from has done a pretty good job getting it where it's at to this point.

02-03 somewhere in there ez txt ( haven't run the serial )

He did away with the stock engine which was blown up and replaced it with a 420 predator

He installed a carts parts plus big block cradle along with a comet 94c clutch

I need to know what belt I need to buy for it and also starter generator mounting before I buy a Vegas carts cradle along with there s/g mount and belt pulley all of that

Anyone that knows plz chime in because I could use all the help I can get thanks guys

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

turbof250

I believe the starter/gen belt comes with the mount from VC. Actually it comes with two belts, one shorter than the other. At least mine did.
A31/4L330 is the size I am using with Geoff's pulley and mount.

dirtyyoda77

Oh I know that just im not sure what belt to use with the carts parts plus mount that is already installed

dirtyyoda77

It just seems like the guy just pieced the thing together once I get it home I'm going to rip that thing down and going to see what is really there

turbof250

Oh, now I see, after I read the entire post. Now that mine is done I am afraid I will get bored with it. That seams to happen with me, dump a ton of cash into something then sell it at a loss so I can start something new. Wife would be upset about this one though.

slonomo

I think you are going to have to measure for the belts. When I did mine I set the engine as far to the rear as it would go, then took a center to center measurement on the clutches. There's a belt calculator here on the site somewhere, you have to know the diameter of your clutches and the width of the belt needed as well.

dirtyyoda77

I know the width is 1 3/16 but the guy has the engine mounted pretty screwed up so I won't know where it truly sets until I rip it apart you wouldn't happen to know what section that belt calculator is at

He has the stock belt on it right now and it's so screwed up but I guess I will see what I got to work with when I get it home

slonomo

I had it saved but I think the website got messed up and they changed it. I'll see if I can find it.

dirtyyoda77

Thanks so much

slonomo

Here it is.

http://www.calculatoredge.com/mech/vbelt%20length.htm