09-11-2014, 12:53 PM | #1 |
Getting Wild
Join Date: Jun 2014
Location: fulton texas
Posts: 93
|
Cart won't start
Everything was working great until i decided to floor it on a long road by the house. I almost top it out until i heard something rattling. I looked back and a piece of sheet metal off the cart had ripped off on one side. I decided to stop and drive it home slowly before things get wrost. I took out my welding machine and started to tach everything back up but before i started, i had to take all the wiring apart. When i was all done i decided to install my tach meter that had just came in. When i was done welding and relize the ground wire from the silenoid was touching the metal i was welding. When i tried to start it after everything was installed, the engine never started again. Could the welding machine fried the silenoid or was it something else. I tripled check all the wirings to make sure i didn't wire it up wrong. The tach is hooked up to the key ignition and it works fine. But when i turn the key there was no click coming from the silenoid. I was thinking maybe the key could be fried or the silenoid. There is volt from the wires so its not the battery.
Sent from my LGL35G using Tapatalk 2 |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-11-2014, 08:01 PM | #2 |
Getting Wild
Join Date: Jun 2014
Location: fulton texas
Posts: 93
|
Never mind i fixed it. My wireing keep losening up during high speeds. If it can break metal then it can rip wires out of connectors. Sorry
Sent from my LGL35G using Tapatalk 2 |
|
|
Similar Threads | ||||
Thread | Forum | |||
cart won't start | Gas Club Car | |||
What's the best cart to start with? | Bike & ATV Engine Swaps | |||
Old Cart Where to Start? | Gas Yamaha | |||
cart won't start............... | Gas Club Car | |||
How to start my cart | Gas Club Car |