Guess What I'm Building!

smokindawg

I used to have a full sized one of these at one time, but had no use for it so ended up making it into a rolling stand for my welder and Plasma cutter.

I was just thinking the last few days about building one of these and was trying to figure out what all I could use to make it.

Well, in digging around, I had all the major components to build it so today got started on it. I'm not finished with it yet, but it's getting closer.

I thought I'd post a couple pictures and let you all guess what I'm making.

Hints:

1) It can and will be used for carts, but also for other things as well.

2) It can be used for a certain part of carts, but also for that same part of other items.

3) It will be used for testing purposes and will make those tests much easier to do.

This should be an easy one. (There is no prize, just know that if you guess it, your due for one of these too.)





I'll give it a little while and if no one guesses, then post a couple more pictures that should give it away.

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

Diceman1530

Engine test stand?

KENNETHC

Bench for Bench starting motors

smokindawg

I gave it away.......... LOL! Nah, you all are just good. I actually used it today, although not finished.

I do have a spot for the ignition switch and a kill switch.

Here are a couple more pictures.





I actually have the 25hp Kawasaki on it right now and it works great. Now just to run wires in a loom and set them up for different ends so I can test any engines. I also need to come up with a starter solenoid to mount on the stand for engines that don't have one on the starter.

I also want to put some extensions on the legs to widen the stance and mount the entire thing on wheels.

smokindawg

In the first post, first picture. You can just see the 25hp that will soon be installed in the G1.

Does anyone else use a run stand/table or do you just bolt it to your bench? Lets see some pictures!