|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
01-17-2015, 04:49 PM | #1 |
Not Yet Wild
Join Date: Oct 2014
Location: NC
Posts: 30
|
Voltage issue after Allteax Install
Guys, I just installed a DCX Alltrax 400 Amp controller, with a 400 amp solenoid and put 2 gauge wire between all batteries, from solenoid to controller and controller to motor On a Club Car IQ system. Programmed the controller and all appears correct.. Problem is, the buzzer barely makes noise, and when the pedal is pressed it throws up a low voltage error light flash.. I have 50+ volts at controller and motor but I have no idea what's going on.. Seems like I am losing voltage somewhere.. Any help would be great!!
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-18-2015, 03:47 PM | #2 |
Gone Wild
Join Date: Feb 2011
Location: Chattanooga TN
Posts: 2,105
|
Re: Voltage issue after Allteax Install
Check your over and under voltage in the control panel. Set the under as low as possible and the over as high as possible.
|
01-19-2015, 07:38 PM | #3 |
Not Yet Wild
Join Date: Oct 2014
Location: NC
Posts: 30
|
Re: Voltage issue after Allteax Install
Ok just an update, the upgraded solenoid we got was bad.. Put another one on and fine. But I still am not getting Yellow/Amber color from the LED light. It continuously stays Green. Received upgraded programs from Allsport to attempt to help with the Lack of Power. So now looking at the MCOR as a culprit for the latest issue.. I hope this is what this is..
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Voltage reducer install | Electric Club Car | |||
Voltage meter install | Electric Club Car | |||
Voltage meter install | Electric EZGO | |||
AC Motor Install issue. | Electric Club Car |