lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 07-07-2015, 02:21 PM   #1
Not Yet Wild
 
Join Date: May 2015
Posts: 2
Default No power at ignition switch

I have a 2012 CC Prec that has no power coming from the OBC wiring harness to ignition switch. I have 48 volts going to OBC and 48v going to motor. Lights work on closed 16v loop. I need some help troubleshooting this as I don't have much experience inside the OBC box. Thanks
MSEcarts is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 07-07-2015, 03:36 PM   #2
Gone Wild
 
theboss20's Avatar
Harley Davidson
 
Join Date: Jun 2014
Location: Buckeye, Az
Posts: 646
Smile Re: No power at ignition switch

I believe there are some fuses to check...it strikes that one of them is in the dash behind the plate where the key and F/R switch are located.
theboss20 is offline   Reply With Quote
Unread 07-07-2015, 06:00 PM   #3
Gone Wild
 
jjance's Avatar
Club Car
 
Join Date: Feb 2011
Location: Chattanooga TN
Posts: 2,105
Default Re: No power at ignition switch

The run/tow switch supplies power to the key sw. That would be a good place to start.
jjance is offline   Reply With Quote
Unread 07-08-2015, 08:31 AM   #4
Dawg Gone Wild
 
TahoeDawgZ71's Avatar
Club Car
 
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 8,002
Default Re: No power at ignition switch

Un plug the 6 pin connector from behind the OBC. Install a small jumper wire in place from pin 2 to pin 6 (red and blue) of the wire harness connector. This will allow the car to run without an OBC. If it runs with jumper in place, replace the OBC
TahoeDawgZ71 is offline   Reply With Quote
Unread 07-08-2015, 02:59 PM   #5
Not Yet Wild
 
Join Date: May 2015
Posts: 2
Default Re: No power at ignition switch

I found a blown 15amp fuse going to the OBC. Not sure how that would have happened. Thanks for the responses
MSEcarts is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
Looking for G14 Ignition Switch Golf Carts and Parts
New Ignition Switch Electric EZGO
No power to ignition switch Electric EZGO
Yamaha G9-Ignition Coil & Ignition Switch-Help Gas Yamaha
Just got a G9 need to know how to wire ignition switch to push pull switch ASAP! Gas Yamaha


All times are GMT -5. The time now is 06:38 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.