|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
07-07-2015, 01:21 PM | #1 |
Not Yet Wild
Join Date: May 2015
Posts: 2
|
No power at ignition switch
I have a 2012 CC Prec that has no power coming from the OBC wiring harness to ignition switch. I have 48 volts going to OBC and 48v going to motor. Lights work on closed 16v loop. I need some help troubleshooting this as I don't have much experience inside the OBC box. Thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-07-2015, 02:36 PM | #2 |
Gone Wild
Join Date: Jun 2014
Location: Green Valley, Az
Posts: 678
|
Re: No power at ignition switch
I believe there are some fuses to check...it strikes that one of them is in the dash behind the plate where the key and F/R switch are located.
|
07-07-2015, 05:00 PM | #3 |
Gone Wild
Join Date: Feb 2011
Location: Chattanooga TN
Posts: 2,105
|
Re: No power at ignition switch
The run/tow switch supplies power to the key sw. That would be a good place to start.
|
07-08-2015, 07:31 AM | #4 |
revolutiongolfcars.com
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 10,224
|
Re: No power at ignition switch
Un plug the 6 pin connector from behind the OBC. Install a small jumper wire in place from pin 2 to pin 6 (red and blue) of the wire harness connector. This will allow the car to run without an OBC. If it runs with jumper in place, replace the OBC
|
07-08-2015, 01:59 PM | #5 |
Not Yet Wild
Join Date: May 2015
Posts: 2
|
Re: No power at ignition switch
I found a blown 15amp fuse going to the OBC. Not sure how that would have happened. Thanks for the responses
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Looking for G14 Ignition Switch | Golf Carts and Parts | |||
New Ignition Switch | Electric EZGO | |||
No power to ignition switch | Electric EZGO | |||
Yamaha G9-Ignition Coil & Ignition Switch-Help | Gas Yamaha | |||
Just got a G9 need to know how to wire ignition switch to push pull switch ASAP! | Gas Yamaha |