|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
07-12-2015, 09:48 PM | #1 |
Not Yet Wild
Join Date: Jul 2015
Location: Georgetown, South Carolina
Posts: 33
|
Wiring question 01 regen 2
On the wiring diagram it shows several wires sonic welded together. The colors are red/white, orange/white, red, red, its like 6 of them. Are these wires positive or negative? This regen is kicking my behind. Please help.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-13-2015, 07:51 AM | #2 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: Wiring question 01 regen 2
That sonic weld junction is the positive feed from the OBC.
Power goes into the OBC via the Red/White wire. When the OBC is not in lockout mode, power goes out on the Blue wire to that junction. When You disconnected the OBC 6-pin connector and jumped the Red/White with the Blue wire, You by-passed the OBC lockout and provided power directly to that junction. You said the reverse buzzer sounded for only 1 second, that is not good since at this point the controller is the only device involved in turning the buzzer ON. The only thing I can think of for you to try is to disconnect the Blue and the Red/White (positions #1 and #2) from the FNR and connect those 2 wires together. If You have a short in the FNR and it is simultaneously sending a Forward and a Reverse signal to the controller, it may malfunction the way You are describing. |
07-13-2015, 09:01 AM | #3 |
Not Yet Wild
Join Date: Jul 2015
Location: Georgetown, South Carolina
Posts: 33
|
Re: Wiring question 01 regen 2
Is there a procedure for testing the controller? Thanks so much for your help.
|
07-13-2015, 09:18 AM | #4 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: Wiring question 01 regen 2
With the OBC by-pass in place and with the Tow/Run on Run:
Put FNR on reverse, verify that You have: +48v on Controller pin #1 Red wire.If You get +48v on those 2 pins and the reverse buzzer does not come ON, the controller is probably bad. |
07-13-2015, 10:41 AM | #5 |
Not Yet Wild
Join Date: Jul 2015
Location: Georgetown, South Carolina
Posts: 33
|
Re: Wiring question 01 regen 2
Ok I will test this today.
|
07-13-2015, 01:17 PM | #6 |
Not Yet Wild
Join Date: Jul 2015
Location: Georgetown, South Carolina
Posts: 33
|
Re: Wiring question 01 regen 2
If indeed I have a controller issue could I upgrade my controller and get a few mph out of this? Or will I need to up motor as well? I have 23'' tires and my speed is 16 mph now. No offroading.
|
07-13-2015, 01:34 PM | #7 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: Wiring question 01 regen 2
Check out this pre-release announcement:
http://www.buggiesgonewild.com/elect...ml#post1175955 You should get over 22mph on 23" tires. |
07-13-2015, 05:33 PM | #8 |
Not Yet Wild
Join Date: Jul 2015
Location: Georgetown, South Carolina
Posts: 33
|
Re: Wiring question 01 regen 2
Getting 48+ volts on of them. I also get 48+ on the large green wire coming out of the controller to the motor. Nothing out of the orange and blue. Do u think the ontoller is history?
|
07-14-2015, 08:41 AM | #9 |
Not Yet Wild
Join Date: Jul 2015
Location: Georgetown, South Carolina
Posts: 33
|
Re: Wiring question 01 regen 2
This morning the buzzer is alarming while in reverse and the tow or run on. Was not doing this yesterday. Wow
|
07-15-2015, 09:42 PM | #10 |
Not Yet Wild
Join Date: Jul 2015
Location: Georgetown, South Carolina
Posts: 33
|
Re: Wiring question 01 regen 2
Replaced obc and controller and still having same issues. Cart is in lock out mode. I can jump the red and blue wire for the obc and get back up alarm. The b silenoid will engage but nothing out of a silenoid.cart will not move. Is there any thing that could make cart go in lock out mode with two different obc?
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Regen 1 / Regen 2 soleniod question | Electric Club Car | |||
Regen 2 Wiring Diagram HELP!!! | Electric Club Car | |||
99 CC 48V non regen motor wiring | Electric Club Car | |||
Regen II wiring | Electric Club Car | |||
2002 non regen wiring diagram needed | Electric Club Car |