lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 07-25-2015, 11:17 PM   #41
Gone Wild
Club Car
 
Join Date: Sep 2012
Location: Alberta - Canada
Posts: 997
Default Re: 2000 48v Club Car Regen 2 Dead

They are new. The XCT model PD+ by Alltrax is supposed to be plug-compatible with your cart and can be programmed to adapt to your older type throttle. As far as I have read, ScottyB (Carts unlimited) has just succeeded in the first test / install of one of these in a Regen 2. You should contact him directly because he will have the most up to date experience with programming it for your application.
joesam is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 07-27-2015, 09:26 PM   #42
Not Yet Wild
 
Join Date: Jun 2011
Posts: 56
Default Re: 2000 48v Club Car Regen 2 Dead

Scottyb , what do you have for me?! Controller is dead!
RoscoeJ is offline   Reply With Quote
Unread 08-05-2015, 08:33 PM   #43
Not Yet Wild
 
Join Date: Jun 2011
Posts: 56
Default Re: 2000 48v Club Car Regen 2 Dead

Ok just got a reman controller from Fsip ,installed ... still nothing ..I've tested every switch ,bypassed the Obc before ,should I disconnect and try jumping out Obc again? Maybey motor is kapuee
Could the Obc make the cart completly dead? I'm not even seeing a twitch!
tested pedal micro ,tested tow run switch ,key switch, new solenoids ,have new batts .....the Only thing I did not test was the Regen 2 motor ,everyone says prob not the motor....I will keep you posted!
RoscoeJ is offline   Reply With Quote
Unread 08-05-2015, 09:24 PM   #44
Gone Wild
 
Sergio's Avatar
Club Car
 
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 4,579
Default Re: 2000 48v Club Car Regen 2 Dead

Yes, the OBC can stop the cart from working.

If you are not getting the reverse buzzer to sound when in reverse, you need to by-pass the OBC lockout circuit.
Sergio is offline   Reply With Quote
Unread 08-05-2015, 11:57 PM   #45
Not Yet Wild
 
Join Date: Jun 2011
Posts: 56
Default Re: 2000 48v Club Car Regen 2 Dead

Ok ,will try tommrow ,and post results!
Could bad motor or anything else hurt new controller?
Could bad OBC cause Controller to go bad?
Should I check motor first?
Tks!
RoscoeJ is offline   Reply With Quote
Unread 08-06-2015, 07:36 AM   #46
Gone Wild
 
Sergio's Avatar
Club Car
 
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 4,579
Default Re: 2000 48v Club Car Regen 2 Dead

A motor with a short on the Field coil can damage the field driver on a new controller, but You would still get solenoid activation and reverse buzzer when on reverse.

If you have reason to believe the motor was over heated, ran at excessive rpm or just want to check it, you can test the motor as follows:

Make sure you disconnect the battery cables first and use 2 wrenches when disconnecting the cables from the motor so the stud does not turn inside the motor.

Jump:
A1 to F1
A2 to F2
Apply 12v or 16v between A1 and A2.

To reverse direction of rotation, Jump:
A1 to F2
A2 to F1
Apply 12v or 16v between A1 and A2.
Sergio is offline   Reply With Quote
Unread 08-06-2015, 06:36 PM   #47
Not Yet Wild
 
Join Date: Jun 2011
Posts: 56
Default Re: 2000 48v Club Car Regen 2 Dead

Ok ,with new controller installed ,I jumped out OBC and ......it moved!!
Wouldn't move with new controller and not jumping out OBC

So I had bad OBC and bad controller ....
Tested and cart wouldn't move with old controller and jumped out OBC ...
Not to mention the 20 tests ,on controller ,pedal....etc...I did....thanks to Sergio!
Thankyou!
RoscoeJ is offline   Reply With Quote
Unread 08-06-2015, 06:44 PM   #48
Not Yet Wild
 
Join Date: Jun 2011
Posts: 56
Default Re: 2000 48v Club Car Regen 2 Dead

Sergio ,is it ok to jump out the braking solenoid ?the big white wire to motor from controller Its a roll away feature,not a hill arround ,here...
I've heard you can ,but wanted to check.to make sure ..
RoscoeJ is offline   Reply With Quote
Unread 08-06-2015, 07:03 PM   #49
Gone Wild
 
Sergio's Avatar
Club Car
 
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 4,579
Default Re: 2000 48v Club Car Regen 2 Dead

Good job on the cart

You can run one of those white cables straight from the motor A2 to the Controller A2.

Remove the DB solenoid (tape the wires) and save it as a replacement for the main solenoid.

You also have to unplug the speed sensor so the controller does not try to do any motor brake as it would be harsh without the resistor coil.
Sergio is offline   Reply With Quote
Unread 08-15-2015, 10:19 AM   #50
Not Yet Wild
 
Join Date: Jun 2011
Posts: 56
Default Re: 2000 48v Club Car Regen 2 Dead

Thankyou..!
RoscoeJ is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
2000 Club Car DS Regen 48v problems Electric Club Car
2000 club car ds regen 2 not moving Electric Club Car
2000 Club Car Regen question Extreme DC!
2000 Electric Club Car regen brake Electric Club Car
1998 Club Car Regen//Dead End! Electric Club Car


All times are GMT -5. The time now is 12:14 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.