2003 CC DS 48v solenoid wiring

buckmanmike

I was cleaning connections today and obviously disconnected some wire from my solenoid accidentally. I have tried looking in the stickies but cannot see the detail to the small wire connections. Can someone post a close up pic or high definition of solenoid wiring. Thx

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

mrgolf

I'll try
image.jpg

buckmanmike

thanks mrgolf. I can't see enough detail. Maybe my computer.
I removed the large terminal wires to clean. Terminal on drivers side had a small wire along with large gauge wire. Passenger side had only a large gauge wire. Cleaned and replaced and cart would not move. No solenoid click. Upon inspection I found a wire with a spade end (I think it was red, cart now 180 miles away), that was unconnected. Did not see a male spade end to connect wire to. Any suggestions.
(I remember seeing another red wire that was connected)

mrgolf

Here is another. I have a relay wired to mine on the right small post.
There is a pink wire from the tow/run switch on the right large post.

image.jpg

CCFanatic

Are we talking about an IQ or Series 03 DS?

buckmanmike

My cart is a series. No run/tow switch.

Sergio

Try this wiring diagram:

http://www.buggiesgonewild.com/attac...car_ds_48v.jpg

mrgolf

Rookie mistake.

buckmanmike

That diagram is much better. Thanks Sergio.

buckmanmike

Got the chance to go to deer camp this weekend. Found where unconnected wire went and reinstalled it. Cart runs great now. Thanks for the wiring diagram.