lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 09-09-2015, 09:15 PM   #11
Gone Wild
 
Sergio's Avatar
Club Car
 
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 4,574
Default Re: Obc troubleshooting

Put the FNR in the position the reverse buzzer is working.

Remove the MCOR 2-pin connector and put a large paper clip jumping the harness socket.

With the key ON you should have +48v at the paper clip.

Press the pedal and if the controller is working, the solenoid circuit should activate.
Sergio is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 09-09-2015, 11:11 PM   #12
Gone Wild
 
gardnerphoto's Avatar
E-Z-GO
 
Join Date: Sep 2008
Location: Eastern NC
Posts: 313
Default Re: Obc troubleshooting

Thanks again ,I will do this tomorrow and post back results
gardnerphoto is offline   Reply With Quote
Unread 09-10-2015, 12:18 PM   #13
Gone Wild
 
gardnerphoto's Avatar
E-Z-GO
 
Join Date: Sep 2008
Location: Eastern NC
Posts: 313
Default Re: Obc troubleshooting

Sergio,jumped with paper clip,no click,no go, have 48 volt on blue wire
gardnerphoto is offline   Reply With Quote
Unread 09-10-2015, 12:35 PM   #14
Gone Wild
 
Sergio's Avatar
Club Car
 
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 4,574
Default Re: Obc troubleshooting

You mean the blue wire at the MCOR 2 pin connector right?

It looks like the controller is bad.

Does the cart offer any resistance and the buzzer beeps when you push it (walk away break)?
Sergio is offline   Reply With Quote
Unread 09-10-2015, 12:41 PM   #15
Gone Wild
 
gardnerphoto's Avatar
E-Z-GO
 
Join Date: Sep 2008
Location: Eastern NC
Posts: 313
Default Re: Obc troubleshooting

Yes blue wire at mcor,have not pushed,test yet,last person who worked on this cart,installed new controller,and did not fix problem(I was told),but I don't know if obc was bypassed at same time....
gardnerphoto is offline   Reply With Quote
Unread 09-10-2015, 06:57 PM   #16
Gone Wild
 
gardnerphoto's Avatar
E-Z-GO
 
Join Date: Sep 2008
Location: Eastern NC
Posts: 313
Default Re: Obc troubleshooting

If I get a new controller ,do I keep obc bypassed?
gardnerphoto is offline   Reply With Quote
Unread 09-10-2015, 07:21 PM   #17
Gone Wild
 
Sergio's Avatar
Club Car
 
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 4,574
Default Re: Obc troubleshooting

The controller has no affect on the OBC, so assuming the pack had enough voltage to start the charger relay, and it only worked after the by-pass, the OBC is bad.

Unless you can get a good deal on an OBC, you may be better off leaving the by-passes in place and getting a smart charger.
Sergio is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
troubleshooting Electric golf carts
RXV troubleshooting help Electric EZGO
DCS Troubleshooting Electric EZGO
94 ez-go troubleshooting.... Electric EZGO
Troubleshooting Help 03 TXT Electric EZGO


All times are GMT -5. The time now is 11:55 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.