Issue with Madjax Genesis 150

mkmars01

Hi, I just purchased a 2013 Precedent and had Genesis 150 rear flip seat installed. I have watched the two videos online and looked at the instructions for installation but cannot find the answer to my issues.

I am worried the brackets holding the seat backs are not properly installed. The front seat is raised about 2 inches higher than the normal stock seat location and is terribly uncomfortable. Furthermore, there are bolts installed into the top holes for the front seat but none in the lower holes. The holes in the bottom location on the seat bracket do not line up with the holes on the seat.

Thanks

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

cartattach

Here are three pictures I had on hand for a Genesis install. Granted these are the 250 with upgraded upper back seat, but the are assembled the same. I personally and not a fan of this design and it take longer to install and the instructions must have been writtin people with midget hands doing the installing as some of the parts are mind numbingly small to get to.

If this doesn't help, let me know and I will get you a person to speak with at Madjax about it.

mkmars01

Thanks for the response but the 250 has completely different brackets.

Sergio

Can You post a picture of your setup in question?

It is hard to visualize what you are describing.