|10-12-2015, 10:07 AM||#1|
Not Yet Wild
Join Date: Jun 2015
ScottyB Conversion Install
Installed Scotty's conversion kit into my '86 club car. It was already 48 volt with a commander motor in it that somehow didn't burn up with the resister setup it had , it was run at 48volt like that for probably 4-5 years, but got 24/25 mph with the 17' street wheels it has on it and lift kit. Anyways went with the 500 amp controller, 2ga wires and the install was a breeze. Cart runs smooth now, 25-26mph on full charge, nice and cool and its nice to see a higher voltage on the meter at 1/4 throttle vs. full instead of it pulling the same amount of juice from the batteries at every throttle position with the resistor.
Got a V-glide, 48volt solenoid, 6 gauge wire kit and resistor setup forsale if anyone is looking.
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
|Where to install ScottyB voltage reducer on 2010 Precedent||Electric Club Car|
|scottyB conversion kit||Electric EZGO|
|Reverse buzzer install after controller conversion||Electric Club Car|
|Install HD Switch Cam from Scottyb, no forward now||Electric EZGO|
|Getting ready for 36v/48v conversion & 500a Controller etc install||Electric EZGO|