|05-08-2016, 09:04 PM||#1|
Not Yet Wild
Join Date: May 2016
I did the unthinkable while installing a rear seat on my 2005 club car DS. I didn't disconnect the batteries first while working and dropped a wrench which landed on the F1 and A1 motor terminals shorting out the system. After the small fireworks I disconnected the battery terminals and reconnected. When I try to engage the engine the solenoid clicks, backup buzzer sounds, and the battery indicator light is on but the car doesn't move forward or back. Any ideas what I may have burnt up, Motor? computer? Iv'e been reading about resetting the OBC? Any advice for my stupidity would be appreciated
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
|05-08-2016, 09:12 PM||#2|
Dawg Gone Wild
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Re: Fried motor?
The controller is fried. I've seen it happen several times. Don't look at it as a mistake, look at it as an upgrade opportunity.
|I think my motor is fried. Need suggestions on what to do next.||Electric EZGO|
|Cable going to motor just fried.||Electric EZGO|
|2007 PDS motor fried||Electric EZGO|
|Motor or Controller Fried||Electric Club Car|
|Fried Motor?||Electric Club Car|