lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 08-08-2016, 06:33 PM   #1
Not Yet Wild
 
Join Date: Aug 2012
Posts: 20
Default Alltrax AXE 4855

Cart setup details below. Debugging an issue where it runs some of the time, but sometimes it just does not move. Been playing at it for a couple of weeks now.

Controller LED is green single flash then solid green. Which should mean go.

I hooked up the AllTrax Controller Pro build 39 software and note that the throttle will show increase on the monitor, but when the cart is not working, it shows Output Current 0 and Battery Amps 0 even though the throttle position % goes up and down.

Until this afternoon, hooking up the cable and software almost always remedies my no go problem after switching tabs in software.

Now, it throws a 0x02 error, which I understand to mean it's saying it's less than -25 degrees C (-13F). Not likely, since it's 90+ degrees F.

I've checked the Controller Input and Output and done a Motor continuity test, everything came out OK. FNR looks good. V-glide output is good. Micro-switches are good.

Any ideas?

93 Club Car DS, ScottyB's HD FNR switch and HD 400amp solenoid, Alltrax AXE 4855. Stock series motor and v-glide.
rettenator is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 08-08-2016, 06:46 PM   #2
Vacationing 12/23 -1/8
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 60,466
Default Re: Alltrax AXE 4855

Errant temp fault code is not good. It's usually a fatal fault not related to temperature at all but control board failure. Call Alltrax 541-476-3565 and ask for tech support. What is the DOM on the unit?
scottyb is online now   Reply With Quote
Unread 08-08-2016, 06:51 PM   #3
Not Yet Wild
 
Join Date: Aug 2012
Posts: 20
Default Re: Alltrax AXE 4855

I got it from you around Sept 2012. I got it to move again a bit, but it goes for about 100 yards and then dies again. If I let it sit about 15 min, it will go a little further.
rettenator is offline   Reply With Quote
Unread 08-08-2016, 08:37 PM   #4
Vacationing 12/23 -1/8
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 60,466
Default Re: Alltrax AXE 4855

Quote:
Originally Posted by rettenator View Post
I got it from you around Sept 2012. I got it to move again a bit, but it goes for about 100 yards and then dies again. If I let it sit about 15 min, it will go a little further.
That's weird. Call Alltrax and tell them that. Then keep us posted.
scottyb is online now   Reply With Quote
Unread 08-09-2016, 11:13 AM   #5
Not Yet Wild
 
Join Date: Aug 2012
Posts: 20
Default Re: Alltrax AXE 4855

OK, I got the machine, but left my info. Will update when I find out.
rettenator is offline   Reply With Quote
Unread 08-09-2016, 11:14 AM   #6
Vacationing 12/23 -1/8
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 60,466
Default Re: Alltrax AXE 4855

They are PST. They answer the phone in 15 minutes.
scottyb is online now   Reply With Quote
Unread 08-09-2016, 05:56 PM   #7
Not Yet Wild
 
Join Date: Aug 2012
Posts: 20
Default Re: Alltrax AXE 4855

So I talked to Alltrax, they said if I was getting voltage from the negative side of the battery to the frame, that was bad. So I checked it, and I was; about 30volts. He said that's the only other thing beyond a bad controller that will cause the 0x02 error.

Attempting to track down how that is, but does that sound plausible?
rettenator is offline   Reply With Quote
Unread 08-09-2016, 06:01 PM   #8
Vacationing 12/23 -1/8
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 60,466
Default Re: Alltrax AXE 4855

Yes I have heard this before but... tracking down and eliminating trace voltage is not easy. Often wet battery cases or on a CC the 16v >12v reducer is to blame.
scottyb is online now   Reply With Quote
Unread 08-09-2016, 06:02 PM   #9
Not Yet Wild
 
Join Date: Aug 2012
Posts: 20
Default Re: Alltrax AXE 4855

Where's the 16v >12v reducer at? (Sounds like that's for 48v)
rettenator is offline   Reply With Quote
Unread 08-09-2016, 06:23 PM   #10
Vacationing 12/23 -1/8
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 60,466
Default Re: Alltrax AXE 4855

Yes 48v carts.
scottyb is online now   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
Alltrax 4855 Golf Carts and Parts
Alltrax 4855 settings Electric EZGO
FS: Alltrax model 4855 Golf Carts and Parts
help with Alltrax AXE 4855 settings Electric EZGO
Alltrax AXE 4855 Electric EZGO


All times are GMT -5. The time now is 11:20 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.