|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
09-24-2016, 05:54 PM | #1 |
Not Yet Wild
Join Date: Jun 2012
Posts: 38
|
96 Carryall, no reverse.
After my motor controller burned up, scorching all the wires on it, I installed a new motor controller and repaired the wires and I just installed a new MCOR conversion kit.
Now it runs fine in forward but no reverse. When I put it in reverse and hit the accelerator the solenoid clicks just like it does when I put it in forward and hit the pedal. What is the first thing I should check? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-24-2016, 08:24 PM | #2 |
Gone Wild
Join Date: Dec 2011
Location: Hampton, GA
Posts: 467
|
Re: 96 Carryall, no reverse.
If it's a series' cart, the reverse switch contacts,...
|
09-24-2016, 08:41 PM | #3 |
Not Yet Wild
Join Date: Jun 2012
Posts: 38
|
Re: 96 Carryall, no reverse.
Thank you. I will check them first tomorrow. I was thinking that they would be ok since the solenoid clicks when I put it in reverse but I will be sure to check them.
|
09-25-2016, 08:59 PM | #4 |
Not Yet Wild
Join Date: Jun 2012
Posts: 38
|
Re: 96 Carryall, no reverse.
I got my Carryall working today. I had downloaded a manual and done every test they had for electrical components and they all checked out fine.
Puzzled, I started over from scratch with everything I did to my cart from the time it broke. First I had gotten a motor controller which was slightly different from the one I had so I went to another web site for instruction on installing it. Hooking it up was fairly simple as I took wires off the old one, one by one, repaired them and put them on the corresponding terminals on the new controller. The wires that went to terminals 2 and 3 were completely burned off so I had to repair them and the web site said it did not matter which of these wires went on #2 or #3 terminal so after repairing them i just pushed them on either terminal. This was the problem. Bad advice on that web site. I tried reversing these 2 wires and everything works now. I won't go back to that web site for instructions again. |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
clubcar carryall grinding in reverse | Gas Club Car | |||
1989 Club Car Carryall No reverse | Gas Club Car | |||
No forward or reverse Carryall 05 electric | Electric Club Car | |||
97 Carryall clutch issue - bangs into reverse | Gas Club Car | |||
My Carryall 272 will not go in reverse. | Gas Club Car |