|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
04-12-2017, 10:01 AM | #1 |
Not Yet Wild
Join Date: Apr 2017
Posts: 10
|
Throttle/Pedal Issues 2012 PH Series Precedent
Hello everyone. I'm new to the world of golf cart ownership. I purchased a 2012 PH series 48v golf cart used from an individual. The speed controller was changed with a refurbished Golfarama 1515 around a week ago. One of my issues is that the cart will only start with the pedal pressed 10-15%. If you go past that the cart will not start. Also once it is going if you go past 50% throttle then cart will completely die. Any ideas on what this could be? I also did a load test with the batteries after a full charge and each one dropped around 1.5v. They are the PD plus batteries and just by judging the letter and date they appear to be 4 years old. Any help would be greatly appreciated!
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-12-2017, 10:55 AM | #2 |
Not Yet Wild
Join Date: Apr 2017
Posts: 10
|
Re: Throttle/Pedal Issues 2012 PH Series Precedent
After reading more on the MCOR issues I wanted to also state this is a 2nd gen pedal assembly
|
04-12-2017, 12:27 PM | #3 |
Gone Wild
Join Date: Jul 2016
Location: Charlotte NC
Posts: 1,165
|
Re: Throttle/Pedal Issues 2012 PH Series Precedent
I am not an expert but I think you are explaining typical MCOR problems.
Try turning the key off and pumping the go pedal 20 times, and see if that has any affect on your issues. As for the batteries they could be on their way out based on age, and what kind of care they received. Check out this Battery information sticker if you have not already seen it: http://www.buggiesgonewild.com/elect...batteries.html Post up your individual and total pack voltages right after full charge and about 10-12 hours later. Aflyer |
04-12-2017, 12:59 PM | #4 |
Not Yet Wild
Join Date: Apr 2017
Posts: 10
|
Re: Throttle/Pedal Issues 2012 PH Series Precedent
No luck with the 20x pedal pump. What's strange is that you can hear the click but when you goto the floor with it, it kicks the solenoid out which makes a lot of sense saying it is the MCOR.
I'll get battery info as soon as I can. Thanks for the help |
04-12-2017, 01:22 PM | #5 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: Throttle/Pedal Issues 2012 PH Series Precedent
You may have an issue within the harness itself.
The Excel cart has 453Ω resistors in each of the throttle wires. You can disconnect the 16-pin Connector from the Controller and the 3-pin connector from the MCOR and measure those resistors. Controller Pin #1 to MCOR - White wireYou should measure approximately 450Ω between each of those connections above. |
04-12-2017, 04:09 PM | #6 |
Not Yet Wild
Join Date: Apr 2017
Posts: 10
|
Re: Throttle/Pedal Issues 2012 PH Series Precedent
I do apologize for my ignorance of using a multimeter. I finally got a reading from all three wires and they checked good at 450 each
|
04-12-2017, 04:10 PM | #7 |
Not Yet Wild
Join Date: Apr 2017
Posts: 10
|
Re: Throttle/Pedal Issues 2012 PH Series Precedent
I also found that this cart has the MCOR 3
|
04-12-2017, 04:28 PM | #8 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: Throttle/Pedal Issues 2012 PH Series Precedent
Hopefully You still have those connectors apart so you can measure the MCOR itself.
You need to measure the MCOR resistance from Pedal Up to Pedal Down. Move the pedal slowly and make sure the resistance change is smooth and not "jumpy". Record both values (Pedal Up and Pedal Down). You can either measure directly at the MCOR pins that correspond to: White to Yellowor Plug the MCOR 3-pin connector and measure from the disconnected controller 16-pin connector: Pin #1 to Pin #2 |
04-12-2017, 04:42 PM | #9 |
Not Yet Wild
Join Date: Apr 2017
Posts: 10
|
Re: Throttle/Pedal Issues 2012 PH Series Precedent
Ok starts at 6670 and tracks down to 1050
|
04-12-2017, 05:39 PM | #10 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: Throttle/Pedal Issues 2012 PH Series Precedent
Those values look normal for an MCOR3.
It may be an issue with that repaired Controller. Unless You have an IQDM type Curtis programmer, it will be hard to diagnose much further. Without an IQDM, the only way to measure the throttle signal is to get a reading on the Yellow wire (Pin #2) at the Controller 16-pin connector, with everything connected, FNR in neutral and key switch ON. It should vary from 0.35v to 4.65v (approximately) from Pedal Up to Pedal down. Perhaps other folks have some ideas. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Electric Precedent Throttle Issues | Electric Club Car | |||
Precedent Speed/Throttle issues | Electric Club Car | |||
2012 Excel Precedent, XCT 400, Admiral MOT-A2 Issues | Electric Club Car | |||
36 volt series throttle issues | Electric EZGO | |||
Put in a used Fe290 into my 99 Club car. Pedal, Governor, Throttle Issues | Gas Club Car |