|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
03-08-2009, 03:19 PM | #1 |
Gone Wild
Join Date: Feb 2009
Location: mississippi
Posts: 213
|
about slack at end of delta arm
i am replacing my kingpin and bushing in the front end of my 95 cc 48 volt and was wondering if the end of delta arm suppose to have a little slack in it because driver side is tighter then pass. and question two is my tie rod are kinda stiff so is it time to change them why i have it down? and two of the tie rod shaft spins when trying to tighten nut up, when not hook on spindle. just so i wouldnt lose nuts while working on it. is that normal, or will it tighten down when hook up and presses into place thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Charger Question - Delta-q | Electric EZGO | |||
How much slack in drive belt | Big Block Talk! | |||
Slack in Steering Wheel | Electric EZGO | |||
Delta Q Battery Charger | Electric golf carts | |||
ITP Delta Steel Rims | Design Center |