OBC Bypass Lockout confermation

PuttPutt

First off thank you for the sticky OBC bypass well done.
I have the obc out of the cart, an 03 CC AQ0337 DS IQ cart runs tow run switch works and charger works. Now I just need confirmation that I understand the lockout wiring and that it applies to this cart. I hope the picture attached. connection between Green wire and black wire in the dc plug.
Connect gray wire from dc port to blue wire at obc connector add 10Kohm-1watt into white wire. Again Thank You.

Attached Images

interlock.jpg (215.4 KB, 0 views)

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

Sergio

I am not sure about what You mean with that "Green wire".

If Your smart charger has the center pin connected to negative inside the charger, then Yes, that is the correct way to wire it so the interlock works.

PuttPutt

I was referring to post #52 in the sticky
"Most likely they ship the 12/2 cord with the smart charger designed to work without the OBC.

In this case You would need to add a wire between the "Sense" pin (green wire on the picture below) and the "Negative" pin (black wire on the picture below)."
Picture attached.

Attached Images

DPI_ClubCar_3pin_plug.jpg (117.1 KB, 0 views)

Sergio

I got you, yes that center pin needs to be connected to negative to put the Curtis controller in lockout mode.

PuttPutt

Thank You Sergio