Installing High Speed Magnet GE Motor

Clive1989

Hi Guys,

I cant begin to explain how much help you have all been over the last few weeks in helping me diagnose and fix problems with my Cart

I have an AQ and i have gathered from a few threads that people recommend the cheaper way to get more out of the cart by installing a magnet.

I have worked out (through the forum) that it is a GE motor by the snap in speed sensor which i believe to be faulty.

I figured i may aswell install the magnet at the same time as installing the new sensor (if that was possible).
Can anyone forward me in the right direction in how to install the new magnet??

Thanks again for everything so far!

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

Sergio

The important part to remember is that you do not have to remove any screws.

You just pry the old magnet off the Motor Armature shaft and tap the new one in place using a large wood dowel until is flush with the end of the shaft.

Get it from David and he will answer any questions You have:

https://www.revolutiongolfcars.com/p...otor-iq-system

WalterM6

On the top of the page click on the search button and type "GE Motor" there should be tons of information and hardluck stories. Follow directions carefully.

Clive1989

Thank you so so much guys!

_ogre

i just went thru the bad speed sensor replacement and did the magnet at the same time
i put the cart on jack stands, pulled the rear pass wheel and inner fender out
at tahoedawg's recommendation i used a paint can lid remover to pull the magnet out

easy peasy

wbhess

OGRE- What was your before and after magnet speeds of your cart? Is yours a Precedent with the GE Motor?

Clive1989

So where exactly does the magnet go? If i pull the sensor out the side of the motor (i'm guessing that is the easy part). Where do i go from there?

TahoeDawgZ71

The magnet is just beneath the sensor. It's lightly pressed onto the end of the armature shaft of the motor.

Clive1989

Thank you all for your help - which way round do i put the magnet and does it have to sit flush with the shaft or does it have to be pushed on further?

Sorry for the daft questions

TahoeDawgZ71

The 8 dots on the magnet need to be facing outward towards the sensor. Tap the magnet onto the shaft until it is flush. Don't knock it all the way down until it stops.