|
09-25-2018, 12:11 PM
|
#1 |
|
Gone Wild
Join Date: May 2013
Posts: 552
|
Removing motor
Don’t want to steal op’s thread but, what if armature is stuck on spline? I have it on it’s side the case came of leaving armature
 Sent from my iPhone using Tapatalk |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-25-2018, 12:19 PM
|
#2 |
|
Gone Wild
Join Date: May 2013
Posts: 552
|
Removing motor help
I’ve never had one stuck like this before. The armature is stuck on the spline and it is currently soaking with penetrating oil. Any other ideas on how to get it off
 Sent from my iPhone using Tapatalk |
|
|
|
|
09-25-2018, 02:44 PM
|
#3 |
|
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,226
|
Re: Removing motor help
Your halfway there. All you gotta do is turn the brake drum around and pick it up and drop it. Might add stand on a ladder or chair to stay clear once it comes off. If you don't succeed at first try again just a little higher.
|
|
|
|
|
09-25-2018, 03:04 PM
|
#4 |
|
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: Removing motor help
Knock the end of the armature with the hammer a few times to try to push it on further and get it to break the rust.
|
|
|
|
|
09-25-2018, 03:08 PM
|
#5 |
|
Gone Wild
Join Date: May 2013
Posts: 552
|
Re: Removing motor help
Will try it all after I pick kids up from school.
So on top of that a motor bolt broke in the attempt of removing cables, All this when this was supposed to be the good motor to replace one with bad brushes. That’s life I guess Sent from my iPhone using Tapatalk |
|
|
|
|
09-25-2018, 04:35 PM
|
#6 | |
|
Gone Wild
 Join Date: Jun 2017
Location: Savannah, GA
Posts: 6,539
|
Re: Rear End Locked up
Quote:
Flip the lower brake drum over and drop the whole axle on it’s end HARD. The weight of the armature should remove it. Club Car DS driver’s club #59 |
|
|
|
|
|
09-25-2018, 05:18 PM
|
#7 |
|
Gone Wild
Join Date: May 2013
Posts: 552
|
Re: Removing motor help
Question why flip the drums vs dropping on studs
Sent from my iPhone using Tapatalk |
|
|
|
|
09-25-2018, 05:24 PM
|
#8 |
|
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: Removing motor help
If you flip the drum and put the lug nuts back on and drop in on the ground you will have no damage to the studs or axle. If you drop it on the studs/no drum you will damage the studs and will never get the lug nuts back on
|
|
|
|
|
09-25-2018, 05:25 PM
|
#9 | |
|
Gone Wild
Join Date: May 2013
Posts: 552
|
Re: Removing motor help
Quote:
Ok Sent from my iPhone using Tapatalk |
|
|
|
|
|
09-25-2018, 06:31 PM
|
#10 | |
|
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: Removing motor help
Quote:
Get a 2lb hammer and give it a few good smacks on the end of the armature. It might break it loose and slide off  |
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Removing Motor | Electric EZGO | |||
| When removing this motor should i--- | Electric Club Car | |||
| Need help removing motor on 07 YDRE | Electric Yamaha | |||
| removing the motor | Gas Club Car | |||
| Trouble removing 36v motor 91 CC | Electric Club Car | |||
Linear Mode
