48 to 12v reducer install issue

Capt Ag

Installed a VOLTSeasy reducer on my 06 DS cart to power a Pyle Bluetooth Amp only. Not headlights. Appears I installed correctly as per instructions and volts are right on input and output. Amp works fine until I press accelerator and then nothing. Let off accelerator and amp comes back on. I haven’t tested voltage output yet when accelerator on... need another set of hands. Is there something obvious that I might be missing? Maybe a ground issue? Appreciate any insight.

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

NoleFan4Ever

Sounds like your pack is weak and when you give it the throttle, the voltage drop is further then your reducer can support.

Hook a DVM up to the pack and lay it on your seat and see where it is dropping to when you hit the throttle.

Note- A fully charged pack is 50.93 volts.....

Capt Ag

Thanks. My pack is good I think. It’s a 4x12 setup less than year old and output is +50v at idle but I don’t know the drop under load so sounds like I need that from both the pack direct and via the reducer output before I can diagnose. Appreciate the help.