2014 non OBC Precedent and I’m thinking about doing an Alltrax 500 install..

twilliams81

I’m thinking about getting Scotty B’s setup but just have some questions first. First of all..has anyone done this on the non OBC carts? Next..I’m going to keep the stock motor so what kind of top speed and torque can I expect with it. Also would I need to upgrade anything other than the solenoid and battery cables? This doesn’t look like a difficult upgrade and I’m sure it’s been covered In The forums before but I figured I’d ask anyway so if nothing else it can be a current thread for anyone else considering doing this. Thanks in advance for any and all info! [emoji1360][emoji1360]


Sent from my iPhone using Tapatalk

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

jonr3

I did the XCT500, 400A solenoid, 2ga. cables, and Alltrax FNKS on my '14 Precedent. Installation was pretty straightforward with no big surprises.

I'm running 22" tires and was getting around 22 - 24 mph on a flat surface with not a very noticeable difference in torque.

Last weekend I installed a PQ Executioner that puts me around 30 mph with a noticeable increase in torque - went from 14 mph up a hill to 18 mph up the same hill.

scottyb

You do not need the XCT500 for a stock motor. I put the XCT300 on my 2014 Precedent and it zipped right up to 23 mph on stock 18" tires... then we put the FSIP speed motor in and hit 32 mph... 27.5 when limiting the rpms to 6000 with the Alltrax software.
XCT400 with the 200 solenoid would be a good middle ground upgrade.
Hope this helps

twilliams81

Thanks Scotty I was thinking about going with the 500 for future motor upgrade purposes. I’ll be calling you in the near future for the order!


Sent from my iPhone using Tapatalk