Electric motor H.P.

PJay

Short of calling the shop, is there a way to check that it was installed?

You might be onto something.

When I ordered the Alltrax from Scottyb, I told him I had a stock G.E. motor and to also set up the 3 position switch. I don't program and did not want to mess with it. That's what he did.

I installed everything and it worked fine except the stutter on the peddle.

So I decided to get new batteries and while talking to the shop guy, I decided to get a new motor and MCOR. What he programmed, I don't know??

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

NoleFan4Ever

It would also be of benefit to you to download the Alltrax Tool Kit and the Software Manual from here https://alltraxinc.com/alltrax-tool-kit/

Then you will be able to connect it to your laptop via a USB Printer cable and then you can check the Field Map, RPM settings, amperage, etc. That will also be needed to set up the Personality switch you purchased.

NoleFan4Ever

And if it is mapped for your stock motor, that is definitely your problem. The tool kit I referenced above will allow you to check that and change it with the correct one.

Just email Alltrax CS here helpdesk@alltraxinc.com and tell them the model motor you have and they will email you the correct map. You can install it with the tool kit in less than 5 minutes. Very easy and it will allow you to get more familiar with your controller as you will have to/need to set each position of your personality switch up for your own personal needs with the same Tool Kit software. (And if you need some help, we will be right here for you!)

scottyb

I have 2 of these motors in my test fleet. One with a 400 amp XCT and one with a 300 amp XCT both on stock tires. One in a 2014 precedent. One in a 2011 TXT48 both carts go 27.5 mph at factory limit 6000 rpms. Both carts rocket to 32 mph without rpm limit. The 5hp rating is easily conservative

Find the correct map for this motor attached.

Attached Files

FSIP_221-48VSPEEDCC-V1.zip (1.0 KB, 0 views)

PJay

Thanks guys. I don't even have a lap top, but I'll see what I can do. It may take more than 5 minutes for me.

I'm a 68 year old 100% disabled Vietnam Veteran with a defib/pacemaker, fake heart valve and sugar. I'm slow at gettin around and gettin up off the floor. But we will try.

Thank's for the help and ideas.

scottyb

Go here to download the TOOLKIT software and user manual or request an RMA # to return the controller for reprogramming.


https://alltraxinc.com/alltrax-tool-kit/

NoleFan4Ever

Where are you located? If near me I can come do it (Have Laptop - Will Travel), if not, if you can get someone with a PC, I can walk you or them through it on the phone.

PJay

I bought the controller from you. Where do I get a RMA# and where do I send it?

PJay

NoleFan4ever,

Good offer but I think Ohio is a little far. However a phone call might not be a bad idea.

NoleFan4Ever

PM sent....