98 club car wont go

tysons_2001

Ive just purchased a 98 club car 48 volt. I bought the cart not running and the previous owner has replaced the motor and one of the solenoids and it still wont run. Ignition works and reverse buzzer works but thats all. Solenoid doesnt make any noises.
I think my cart has the regen motor as it has a tow/run switch and also has dual solenoids. What should i be testing for?
Batteries test at 48v and there is 48v at the solenoid also

Sent from my SM-G960F using Tapatalk

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

LukeL

Regen 1? What does the controller look like? Is it shaped like a T and says “Club Car” on it?


Club Car DS driver’s club #59

NoleFan4Ever

That would be a Regen 2 Cart so the 2nd solenoid is only for the dynamic brake. On the 1st solenoid you need to be checking for the 48v at the 2 small posts. If not, you need to see where you have lost the permissive at (on the Pos activation side (Light blue wire) or the Neg activation wire (Blue w/Wht Stripe))

Here is a diagram/schematic

Attached Images

CC_powerdrive_plus_(regen2).jpg (499.5 KB, 0 views)

tysons_2001

Ok so im not getting any negative on blue white wire. Im thinking the issue is either the throttle or the speed controller. Where should i be testing next?

Sent from my SM-G960F using Tapatalk

Roxyflash

Have you tried bypassing the obc ?

tysons_2001

Yes ive bypassed the obc. Connected blue and white wire with a fuse. The reverse buzzer works but no go in either reverse or forward. Tried manually triggering the solenoid and still no go. Solenoid is working fine when triggered manually. Ive tested the microswitch in the throttle mechanism and that seems to be working correctly but have not tested the resistance of the throttle as im not sure which wires and what resistance to test for. Should the solenoid engage once the microswitch is activated in the throttle or once the computer senses resistance?

Sent from my SM-G960F using Tapatalk