|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
09-26-2019, 06:07 PM | #1 |
Not Yet Wild
Join Date: Jul 2019
Location: Edgewater, MD
Posts: 9
|
2014 Precedent shudders but doesn't move
So we have a 2014 precedent that I put a alltrax controller in, and the upgraded solenoid, cables and an Admiral motor in. All this was done about 6 weeks ago. It ran great until last weekend. My wife took the kids for a ride. Stopped at a playground for about 15 minutes and it has never moved under its own power since.
When you press the accelerator the cart shudders like it wants to move but can't. Same thing in forward and reverse. The batteries are new Trojans. We brought it home and put it on the charger. Resting voltage is 51.0 I hooked up the laptop to it using the alltrax software it shows the key switch on and off, it shows the reverse switch or forward switch when selected, and no error codes. When you press the accelerator the low battery error light turns red, and the pre-charge fail, and shutdown errors change color, just the words, not the actual indicators. The words change to blue. Where all the other words for the error indicators are grey. The low battery error words turn blue as well. Battery voltage on the gauge section shows 50.1 volts with the accelerator not pressed and drops when you press it. It varies in voltage when the accelerator is pressed but seems to hover around 40-45v The throttle percentage seems about right, starting at 0 and going up to 100% when you get the pedal to the floor. Also the shuddering gets stronger the further you press the pedal, but it still doesn't move. Any suggestions would be greatly appreciated. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-26-2019, 08:00 PM | #2 |
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,226
|
Re: 2014 Precedent shudders but doesn't move
Try connecting your motor up in the standalone mode as pictured. Use two 8v batteries and put your cart on jackstands. The motor stays connected to the cart. Use battery jumper cables for quick connections.
When you towed it home did you put the run/tow sw in tow? Additional thought. Try pushing the cart by hand. If it doesn't move easy it's probably the motor and no need for the above test. Remove motor to inspect. |
09-26-2019, 10:31 PM | #3 |
MOD of all BS!
Join Date: Sep 2011
Location: Florida
Posts: 17,477
|
Re: 2014 Precedent shudders but doesn't move
Your solenoid is stuck open and is not closing in. Thus the reason the precharge and low battery alarms are coming in after you depress the pedal. If you listen closely, you will notice you do not hear that loud click coming from the solenoid. All you are getting is the small amount of current coming from the precharge provided by the Run/Tow switch to the controller. (I swear I do not know whats going on with these solenoids lately, but if that is an MJZ-400, this will be the 9th I have had or heard of in the last 6 months. 2 of them were on personal carts I own.)
Jack the cart up on one side, have the Ms's depress the pedal as you are tapping strongly on the solenoid housing. Usually 3 or 4 good taps and you will hear it click and then the wheels will turn normally. Note- If it is not jacked up, have it turned towards the open field as when it closes in it will take off like a scorned banny rooster... |
09-27-2019, 11:10 AM | #4 |
Not Yet Wild
Join Date: Jul 2019
Location: Edgewater, MD
Posts: 9
|
Re: 2014 Precedent shudders but doesn't move
There is no clicking, I will do a tap test this evening. But I think you are on the right track with this diagnosis.
Makes sense. Hopefully this is still under warranty, I just got it a few months ago. I will check with the seller once I run this test. |
09-27-2019, 01:54 PM | #5 |
Not Yet Wild
Join Date: Sep 2017
Posts: 68
|
Re: 2014 Precedent shudders but doesn't move
Had the same problem with mine once and it turned out to be my 3 month old 400 amp solenoid went bad.
|
09-27-2019, 03:02 PM | #6 |
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: 2014 Precedent shudders but doesn't move
I agree, If you don't hear the solenoid clunk, start there.
Do you have a diode on the the coil side (small terminals) of the solenoid? |
09-27-2019, 03:53 PM | #7 |
MOD of all BS!
Join Date: Sep 2011
Location: Florida
Posts: 17,477
|
Re: 2014 Precedent shudders but doesn't move
Oh no, that is it. That is what brings in the 2 alarms you are getting. That is why I explained it all out so you could know "why".....
|
09-28-2019, 12:40 PM | #8 | |
Gone Wild
Join Date: Nov 2018
Location: Lady Lake, FL.
Posts: 457
|
Re: 2014 Precedent shudders but doesn't move
Quote:
Sent from my SM-G960U using Tapatalk |
|
09-28-2019, 05:03 PM | #9 |
MOD of all BS!
Join Date: Sep 2011
Location: Florida
Posts: 17,477
|
Re: 2014 Precedent shudders but doesn't move
Replaced 6. The others were members here I helped or someone that was willing to run it as is. I will not. That is like riding a rattle snake - You never know when it is going to reach out and bite you....
Originally I thought mine were due to Lithium packs pushing the limits of the contactor, but have had several now that were 48v packs..... |
09-28-2019, 05:07 PM | #10 |
MOD of all BS!
Join Date: Sep 2011
Location: Florida
Posts: 17,477
|
Re: 2014 Precedent shudders but doesn't move
And since everyone of them are made in China, it may be an issue we just have to work thru as they are used all over the industry and surely they are getting complaints...
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2014 precedent will not move after intense pressure wash | Electric Club Car | |||
2014 Yamaha 48v won't move | Electric Yamaha | |||
2014 ezgo will not move | Electric EZGO | |||
EZGO PDS Shudders/Won't Move with Much Diagnosing | Electric EZGO | |||
Cart shudders and will not move. | Electric EZGO |