|
|
|||||||
| Electric Club Car Electric DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
10-15-2019, 09:49 PM
|
#1 |
|
Not Yet Wild
Join Date: Oct 2019
Posts: 3
|
1980 club car won't move
1980 36 volt club car was working fine the. Kids were ridding it and it quit working. one of the red wires going to the motor from the forward reverse switch was melted a little by the solenoid resistor coil and the motor was hot. I replaced the wire and it still won't move in forward or reverse I can here the solenoids clicking, I'm thinking maybe the forward reverse switch got fired but I'm not sure how to test it . I checked the micro switch for continuity and it does have continuity. One thing my daughter said her friend was doing donuts and switching from forward to reverse very quickly.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
10-15-2019, 10:05 PM
|
#2 |
|
Gone Insane
 Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,214
|
Re: 1980 club car won't move
Pull the cables off and test the motor. These carts are not made for that new, and it's 40 years old.
|
|
|
|
|
10-15-2019, 10:40 PM
|
#3 |
|
Gone Insane
Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,214
|
Re: 1980 club car won't move
Use 2 wrenches so you won't spin the stud. Soak the nuts/studs first with PB Blaster or something similar. And, as old that thing is the exposed threads should probably by cleaned with a wire brush depending on condition.
|
|
|
|
|
10-16-2019, 04:55 PM
|
#4 |
|
Gone Wild
Join Date: Jun 2017
Location: Savannah, GA
Posts: 6,539
|
Re: 1980 club car won't move
A little higher quality...
 |
|
|
|
|
10-16-2019, 07:55 PM
|
#5 | |
|
Gone Insane
Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,214
|
Re: 1980 club car won't move
Quote:
 |
|
|
|
|
|
10-20-2019, 08:29 AM
|
#6 |
|
Not Yet Wild
Join Date: Oct 2019
Posts: 3
|
Re: 1980 club car won't move
I got the cart apart first access to the motor I cleaned it up good and can not see any labels by the studs to figure out which ones are a1 ,a2 ,s1,s2
|
|
|
|
|
10-20-2019, 08:47 AM
|
#7 |
|
Not Yet Wild
Join Date: Oct 2019
Posts: 3
|
Re: 1980 club car won't move
Picture of motor
|
|
|
|
|
10-24-2019, 02:15 AM
|
#8 |
|
Gone Insane
Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,214
|
Re: 1980 club car won't move
I'm not familiar with that motor, but I would think it would be stamped or embossed somewhere on it. Shouldn't be that hard to find out. Can you find any other numbers?
|
|
|
|
|
10-24-2019, 06:43 AM
|
#9 |
|
Gone Wild
Join Date: Jun 2017
Location: Savannah, GA
Posts: 6,539
|
Re: 1980 club car won't move
The A1 and A2 should be on the end cap, with the S1 and S2 on the motor case. It’s just finding out which is which now...
|
|
|
|
|
10-24-2019, 08:26 AM
|
#10 |
|
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: 1980 club car won't move
The A1 vs A2 or S1 vs S2 doesn't matter as they can be used interchangeably.
I would not power that motor until You fix that brush wire hanging out of the Motor. |
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 1980 club car | Electric Club Car | |||
| 1980 Club Car Gas won't move in reverse | Gas Club Car | |||
| 1980 36 volt clicks, won't move | Electric Club Car | |||
| 1980 Club Car | Lifted Golf Carts | |||
| 1980 club car won't go | Electric Club Car | |||
Linear Mode
