|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
10-21-2019, 11:36 AM | #1 |
Not Yet Wild
Join Date: Nov 2015
Location: Florida
Posts: 33
|
2013 club car president no power
2013 club car president stopped running. Towed it back home. Looking for ideas of what could be the problem. No clicking noise when I turn the key. When I put the charger on it’s like normal & charging. Batteries are all at least 8.5 volts. Any ideas would be appreciated. I was told by my neighbor it’s either the obc, or solenoid. I thought if it’s charging it wasn’t the obc, but what do I know. Thanks for any help in advance.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-21-2019, 11:45 AM | #2 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: 2013 club car president no power
It probably blew the 15 amp fuse in the main harness.
The 15 amp ATO blade fuse is located in a inline fuse holder at the bottom of the harness and it is accessible if you pop the plastic cover on the back of the cart where the electronics are located. |
10-21-2019, 12:53 PM | #3 |
Not Yet Wild
Join Date: Nov 2015
Location: Florida
Posts: 33
|
Re: 2013 club car president no power
The fuse is good. Also it was towed back in the toe position.
|
10-21-2019, 01:07 PM | #4 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: 2013 club car president no power
If the reverse buzzer is making a sound when the FNR is in reverse, the next likely possibility is the Solenoid.
Not the easiest part to test in place in your model cart but if You can clip alligator leads on the solenoid wires you can test if the controller is trying to activate it. |
10-21-2019, 01:42 PM | #5 |
Not Yet Wild
Join Date: Nov 2015
Location: Florida
Posts: 33
|
Re: 2013 club car president no power
I tried filling a link with instructions on how to test for bad solenoid. Following there instructions solenoid is good. If so would my next thing to look for is the obc. If so any ideas on testing or troubleshooting obc ?
https://axleaddict.com/auto-repair/H...a-Bad-Solenoid |
10-21-2019, 01:59 PM | #6 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: 2013 club car president no power
If the solenoid clicks and you get continuity on the big posts then you are fine there.
The OBC lockout circuit is easy to test, as I mentioned if the reverse buzzer is working when the FNR is in Reverse the OBC is not the problem. Disconnect the MCOR 2-pin connector and verify You have pack voltage on the Blue wire when the Key Switch is turned ON. Use a large paper clip to jump the two terminals on the harness connector, that will by-pass the MCOR micro-switch. Test if the cart works. |
10-21-2019, 02:02 PM | #7 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,187
|
Re: 2013 club car president no power
Check for positive pack voltage on pin 5, lt blue wire. That is the obc interlock. If power obc is good.
|
10-21-2019, 02:32 PM | #8 |
Not Yet Wild
Join Date: Nov 2015
Location: Florida
Posts: 33
|
Re: 2013 club car president no power
Sorry I feel this is a little over my head so please be patient with me. This may be a silly question but when I do all these test is the toe switch supposed to be in the toe position. When I tried to test the solenoid following the instructions from the link I did it in the toe position. I never heard the clicking noise from the solenoid when testing
|
10-21-2019, 02:51 PM | #9 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,187
|
Re: 2013 club car president no power
If it is tow there is no power to the controller. Must be done in run mode. With that said don’t unplug any connections while in run mode.
|
10-21-2019, 02:52 PM | #10 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: 2013 club car president no power
I guess it is fair to say the Solenoid has not been tested.
First, just listen for the Reverse buzzer as it does not involve any measurements. Next test the MCOR as it is the easiest of the two tests. If the MCOR 2-pin connector has power on the Blue wire with the Key ON and the cart does not move with the 2 pins on the harness side jumped, then test the Solenoid. I am assuming You are not hearing the Solenoid click. Disconnect the two quick connector terminals on the Solenoid and place your meter probes on the wires. Turn the Key Switch ON and press the pedal, if the voltage goes from 0 to pack voltage, replace the Solenoid. Make sure the Tow/Run switch is on Tow for setting up the tests but on Run when you are actually testing. Keep one of the rear wheel raised during tests. |
|
|
Similar Threads | ||||
Thread | Forum | |||
No power to 2013 Club Car Precedent | Electric Club Car | |||
2013 club car president will not start | Gas Club Car | |||
2013 club car Precedent vs 2013 EZGO RXV | Electric Club Car | |||
Club Car President | Electric Club Car | |||
Club Car President. | Big Block Talk! |