Axle identification? - Club Car Electric

rjs1035

First post! Hello all...

I'm reviving a Club Car that was totaled in a wreck and almost everything has been fixed, except the bent flange on the passenger side rear axle. Not sure I can get it back to square, so a replacement axle is my only viable option.

I tried to find a junk-part replacement but it looks like the axle I have is circa 1985 ish, but I'm not sure, as there are no markings on the cart to positively Id this thing.

I have removed the axle - The differential has 'Made in Japan' on it, but no reference (at least that I can find) - I assume it's a Kawasaki...

I called the junk-parts people and they say they cannot find a replacement - The only thing I have to go on is the measurements / config. The axle measures, from the inside flange to the end of the axle, at 20 7/8 inches - The flange is 'squared' with rounded edges, 4 lugged, and has a C clip access hole in it. In order, I have the flange, a c-clip (over an axle-shaft bearing spring), the bearing, a bushing and then the actual shaft with a 13 splined end.

What do I have? Is there a manual-page referencing this axle with the part #? Any help is greatly appreciated and I can post a picture later on...

thanks

Rich

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

scottyb

Hello, I have your parts! Kawasaki made it. I had a 1985 CC with a broken diff housing so I saved the axle housings complete... I have the entire passenger side in good order. Housing, bearing, seal,& axle.

miferrel

To BGW

rjs1035

cool - how do I contact you?

rich

scottyb

Post your email for a few minutes here....And I will contact you.

rjs1035

aok

scottyb

Email sent ..... requesting a pic of your axle. 2 different rearends were used by graziano and kawasaki.... I have both styles. Delete your email here if you got mine so you don't get spammed

scottyb

Is this the axle we you are looking for?

Attached Images

IMG_2819.jpg (131.0 KB, 65 views)

rjs1035

...at first glance, that looks like the puppy. The key parameters, as posted before, are 13 splines and 20 7/8" from the inside flange to the end of the splined side. I'll post / send you a pic. later today...Many thanks!

scottyb

The axle is the rusty thing. The puppy is pictured below Okay lemme know