93 38V Electric Club Car - Resistor, 1 Solenoid

mike1234

I originally posted that I had a 95CC with a controller, and that is not the case. I have a 93CC Electric 38V with 1 solenoid and resistors. I replaced a wire on the forward/reverse switch and I messed it up somehow. I took two pictures, one of the switch in question. It has 5 copper terminals and I would LOVE it if someone could tell me where the 6 wires are supposed to go.

Here's what I have:
1. 4 gauge wire coming from motor. When looking towards the back of the cart, it sits on the top of it. It's purple.
2. 12 gauge wire coming from the ignition. It's red.
3. 4 gauge wire coming from the motor. When looking towards the back, it sits on the bottom of it. It's brown.
4. 4 gauge wire from the only solendoid. Driver's side.
5. 4 gauge wire from the positive terminal of one of the batteries in the middle.
6. 10 gauge wire from the fuse/charger assembly. It's red.


Thanks for the help! If you're looking at the switch, if we can start on the outside right and call that terminal A and run along to the bottom to B and then bottom left C and then above that D and to the right E. I need all the help I can get.

Attached Images

	93CCswitch.jpg (38.6 KB, 10 views)
	93CCinside.jpg (50.7 KB, 12 views)

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

scottyb

Welcome to BGW mike1234 I ave had a couple of these, Good carts
CHeck this pic out .... it is a rough sketch from an 89 w/ same system.....does that help?

Attached Images

80s CC F&R.jpg (58.2 KB, 20 views)

mike1234

Thanks, Scotty. I used that in conjunction with a picture that I found of the motor labeled as S1, A1, etc. It worked perfectly. Thanks a bunch.

GLEEMO

Just a FYI for future reference it is 36 Volt not 38 Volt