lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 01-07-2008, 08:09 PM   #1
Gone Wild
 
Join Date: Oct 2007
Location: Sebring,Florida
Posts: 156
Default 99 cc won't go

99 48v series won't go.got solenoid click so I was checking the values of restiance on the v-glide and they are incorrect.Changed out the resistors and same reading.Am I even on the right track in trying to solve the issue.I have a manual.Any help would be appriciated.
Tom
ltmoeller is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 01-07-2008, 09:11 PM   #2
Just me. .
 
phasetim's Avatar
Club Car
 
Join Date: Sep 2007
Location: Pensacola, FL
Posts: 1,092
Default Re: 99 cc won't go

solenoid may be clicking, that doesn't neccessarily mean you are getting voltage to your controller...

questions:

1. does your car attempt to bump forward slightly?
2. is everything stock?


if it bumps forward just a little, then change th solenoid...
~~~
if not, then check your f/r switch, make sure you don't have a burn there, then check motor wires and controller wires etc..etc...
phasetim is offline   Reply With Quote
Unread 01-07-2008, 09:28 PM   #3
Gone Wild
 
Join Date: Oct 2007
Location: Sebring,Florida
Posts: 156
Default Re: 99 cc won't go

It does not bump at all.Cart is stock.I was following the trouble shooting guide after checking solenoid and I was testing the v-glide,got late and went home.I didn't think about the f and r switch.I have a spare one I could hook up tomorrow.
Tom
ltmoeller is offline   Reply With Quote
Unread 01-07-2008, 10:57 PM   #4
Just me. .
 
phasetim's Avatar
Club Car
 
Join Date: Sep 2007
Location: Pensacola, FL
Posts: 1,092
Default Re: 99 cc won't go

that is the route I would check, if the v-glide is sending an inaccurate signal, you will usually do something..

more than likely its a wire, controller, or f/r
phasetim is offline   Reply With Quote
Unread 01-07-2008, 11:06 PM   #5
Gone Wild
 
Join Date: Oct 2007
Location: Sebring,Florida
Posts: 156
Default Re: 99 cc won't go

Can you tell me what usually causes an inacturate signal to the v-glide.I have been doing the readings thru the 6 pin connector?
Tom
ltmoeller is offline   Reply With Quote
Unread 01-08-2008, 08:24 AM   #6
Just me. .
 
phasetim's Avatar
Club Car
 
Join Date: Sep 2007
Location: Pensacola, FL
Posts: 1,092
Default Re: 99 cc won't go

you are better off doing the readings off the wires connected to the speed controller...

innaccurate v-glide readings, on your car, are caused by the resistors on the back...
phasetim is offline   Reply With Quote
Unread 01-08-2008, 08:28 AM   #7
Gone Wild
 
Join Date: Oct 2007
Location: Sebring,Florida
Posts: 156
Default Re: 99 cc won't go

Thanks I am going to check what you say this motning and will post results.
Tom
ltmoeller is offline   Reply With Quote
Unread 01-08-2008, 08:46 PM   #8
Gone Wild
 
Join Date: Oct 2007
Location: Sebring,Florida
Posts: 156
Default Re: 99 cc won't go

I have ruledout the v-glide.I am testing the controller.Removed half speed reverse wire.Put + on + 48 volt bat then - on blue wire on f and r and I get no 48 volt reading.I then took two wires off controller small blue and small yellow I believe and I get 5000k at rest and 0 at full throttle.I think It is the controller.
Tom
ltmoeller is offline   Reply With Quote
Unread 01-08-2008, 09:41 PM   #9
Just me. .
 
phasetim's Avatar
Club Car
 
Join Date: Sep 2007
Location: Pensacola, FL
Posts: 1,092
Default Re: 99 cc won't go

5k - 0k is normal... v-glide is good... as is the micro-switches and wiring coming from it..

solenoid is clicking so computer is not your problem, neither is the activating micros witches...
~~~~~~~~
which blue wire did you test from? the blue wire thats on the moving cam or the blue wire on the solid doesnt move part?

if its the solid part then you should have a reading there when you have the pedal depressed.. so you are right either controller or wiring from the controller. It's nine years old, its had a good life.. :-)
phasetim is offline   Reply With Quote
Unread 01-09-2008, 07:46 AM   #10
Gone Wild
 
Join Date: Oct 2007
Location: Sebring,Florida
Posts: 156
Default Re: 99 cc won't go

I am testing at the solid blue wire on f and r switch.I have a 04 cc so I'll put that controller on and see if that solves this issue.
Thanks,Tom
ltmoeller is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes



All times are GMT -5. The time now is 08:07 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.