03-27-2010, 08:34 PM | #1 |
Not Yet Wild
Join Date: Mar 2010
Location: TX on the coast
Posts: 26
|
Alignment again
I have a 6" spindle lift with 12" rims and 23" tires. I can not seem to get the alignment right. When I toe them in 1/8 - 1/4 the right (passenger) tire grabs when turning left. The only fix I have found is to toe the right tire out until it starts scrubbing while going straight. Any suggestions are welcome as they relate.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-27-2010, 08:39 PM | #2 |
Gone Wild
Join Date: Jul 2008
Location: Reddick IL
Posts: 11,220
|
Re: Alignment again
Not sure but are the links the same length so the steering arm is centered?
|
03-27-2010, 08:46 PM | #3 |
Gone Wild
Join Date: Jul 2008
Location: Reddick IL
Posts: 11,220
|
Re: Alignment again
I wasn't clear, the pitman arm must be centerd or the ackerman will be off and you will scuff the tires.
|
03-27-2010, 08:49 PM | #4 |
Not Yet Wild
Join Date: Mar 2010
Location: TX on the coast
Posts: 26
|
Re: Alignment again
That is a good question. I have center them according to the threads, but am not sure how that relates to the steering arm. I made an assumption that if they looked even from the front that they were even. I know nothing about alignment and have been throwing darts at the board trying to figure it out.
|
03-27-2010, 08:56 PM | #5 |
Not Yet Wild
Join Date: Mar 2010
Location: TX on the coast
Posts: 26
|
Re: Alignment again
"I wasn't clear, the pitman arm must be centerd or the ackerman will be off and you will scuff the tires."
Thanks for the reply. Looks like I have additional reseach to do before I can resovle. I really have no clue about alignment. 1. Google pitman arm 2. Google ackerman |
03-27-2010, 10:41 PM | #6 |
ZONE FREE ZONE
Join Date: Nov 2009
Location: lauderdale by the sea
Posts: 571
|
Re: Alignment again
Have the wife swing the steering from left to rt a few times while you lay under the cart, have her stop when the arm off the steering is centered(it doesn't matter where the tires are) now redo your alignment so both tires have a slight toe in.
|
03-27-2010, 10:46 PM | #7 |
Gone Wild
Join Date: Sep 2009
Location: Forest City N.C.
Posts: 2,660
|
Re: Alignment again
All you have to do ie disconnect the tie rod where it comes out of the rack.Then you want to take the rear shaft and loosen the jam nuts and adjust the tow in and out of the front wheels by turning the sleeve in or out.you want an 1/8 inch of tow in.Once you get that done and the wheels are straight you need to adjust the tie rod end on the rack to fit the new position.You need to keep the wheel straight while doing this.You can do this with the wheels off the ground.Make sure you put cotter keys in when you get done.
|
03-28-2010, 09:50 AM | #8 |
Not Yet Wild
Join Date: Mar 2010
Location: TX on the coast
Posts: 26
|
Re: Alignment again
Thanks guys. I will be working on it today.
|
03-29-2010, 02:17 PM | #9 |
Not Yet Wild
Join Date: Mar 2010
Location: TX on the coast
Posts: 26
|
Re: Alignment again
Update:
Did the alignment again (thanks for the info) and took it for a spin only to find that the right started grabbing again. Jacked it up and found that the kingpin on that side was loose. Bearings and bushings on that side are shot, probably due to the loose kingpin. I will be replacing bearings/bushings as well as installing a bump steering kit. I hope that does it. |
03-29-2010, 03:53 PM | #10 | |
Gone Wild
Join Date: Sep 2009
Location: Forest City N.C.
Posts: 2,660
|
Re: Alignment again
Quote:
|
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Front-end alignment | Gas Club Car | |||
Clutch Alignment | Big Block Talk! | |||
alignment of G1 | Gas Yamaha | |||
alignment ? | Electric EZGO | |||
Alignment for a 07 stx | Gas EZGO |