'95 CC just clicks

chrisj

I have a 1995 CC that had a battery cable rub through against another battery post. Replaced the cable and now the car wont move. The charger works ok and the reverse horn comes on when put in reverse. I have voltage to the micro switches on the f/w switch when you push on the peddle and you can hear the solonoid click but no go. Any ideas what could be wrong?

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

scottyb

Welcome To BGW !!!

Can you tell us if the cart is a resistor coil or controller cart?

shadowman

95 i think would be a controller cart but? anyways even though the soleniod clicks jack the rear up and jump the large post turn key on press pedal see if cart runs if so replace solenoid, also double check your cables and test your batteries.............................post what you find........by the way Hi there Scottyb.....................................

scottyb

Hey there Tom Just seen a 95 coil cart last week, seems they made em till 2004 for the golf fleets? Cheap to make and run ya know

modeem

Having same problem with my '87.

http://www.buggiesgonewild.com/elect...st-clicks.html

I tried voodoo and Mayan style sacrifice, but I think I'm going to have to shrink myself so I can fit to test out the accelerator box with the old multimeter.....fun.

I'm keeping my eye on your post just in case you find something else.

shadowman

scootyb, i havn,t seen one yet than again i don,t get to work on many carts newer than 2001 but have yet to even see a 95 resistor cart....................................

scottyb

Yup, seeing some here and a friend saw an 03 resistor cart in the midwest .... So it is all true

chrisj

It is a controller cart. The batterys are charged (48 volt system). Lifted up the rear of the cart and ran a jumper wire across the two large posts of the solonoid while pressing on the peddle and still nothing. When I press on the peddle I am getting voltage to the controller from the multistep pot.

scottyb

Check the motor for any unwanted continuity. should have continuity between S1 and S2 & between A1 and A2 but not between any S and A terminal.

chrisj

There is continuity between S1 and S2 . There is continuity between A1 and A2. There is no continuity between the S and A terminals.