lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 05-14-2010, 10:35 PM   #1
Not Yet Wild
Club Car
 
Join Date: Apr 2010
Location: dinwiddie va
Posts: 20
Default 1996 cc wont move

ok here we go

i have a 1996 club car i have new batteries new selonid new motor new curtis controller and and new beefed up f&r switch i had to replace one of the limit switches there is only 2 things left obc and potentioner what could it be i have spent enough to buy a new one
mikemathis18 is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 05-14-2010, 11:28 PM   #2
Not Yet Wild
 
modeem's Avatar
 
Join Date: May 2010
Location: Gainesville-Ocala Florida
Posts: 61
Default Re: 1996 cc wont move

sounds like the work of gremlins.


don't feed them, or lend them your multimeter....You're going to need it.

Test your batts (refer to stickies). Find the diagram. Follow the flow starting from positive battery terminal till you find something not doing what the diagram says it should. Everything is hard to get to, and it takes forever.

But on the upside , it sounds like you might end up with enough spare parts to build another cart.
modeem is offline   Reply With Quote
Unread 05-15-2010, 11:56 AM   #3
Gone Wild
 
OLD MEC's Avatar
Club Car
 
Join Date: Mar 2009
Location: South Texas
Posts: 2,391
Default Re: 1996 cc wont move

You didnt tell us what 1996 club car you have, but I assume its a 48 volt cart as you mention the obc. Is your cart a series model or a regen or IQ cart? all which can make a difference in finding problem solutions. The OBC is only to control your factory battery charger. It sounds like you have a problem with your Potentiometer ( pedal speed control ).
What unit do you have? There were two different units used in 1996, one is V Glide ( pie shaped unit mounted between batterys under drivers seat ) or a black unit mounted under drivers side floor board connected directly to pedal? The last is no longer available, while the V glide is still available complete or parts. The V glide has small resistors mounted on back side of glide box that when internal contacts are made varies power to solid state controller.
Please advise of what type you have.
OLD MEC is offline   Reply With Quote
Unread 05-16-2010, 09:24 PM   #4
Not Yet Wild
Club Car
 
Join Date: Apr 2010
Location: dinwiddie va
Posts: 20
Default Re: 1996 cc wont move

sorry it is not the v glide its actually the pot that they only made for those two years and i can still get the pot remaned on ebay for about 150
mikemathis18 is offline   Reply With Quote
Unread 05-16-2010, 09:25 PM   #5
Not Yet Wild
Club Car
 
Join Date: Apr 2010
Location: dinwiddie va
Posts: 20
Default Re: 1996 cc wont move

1996 cc 48 volt model #a9642-536366 sorry all i have got it for a project
mikemathis18 is offline   Reply With Quote
Unread 05-16-2010, 10:13 PM   #6
Cartsunlimited.net
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 64,079
Default Re: 1996 cc wont move

OKAY so do you have a basic wiring diagram of the cart yet? The pot is a simple ohm test 0-5k ....... what do you have?
scottyb is offline   Reply With Quote
Unread 05-17-2010, 02:52 PM   #7
Not Yet Wild
Club Car
 
Join Date: Apr 2010
Location: dinwiddie va
Posts: 20
Default Re: 1996 cc wont move

ok i went ahead and ordered a potentiometer i have another question my solenoid has a resistor that is not built inside it has two small lines coming off of it. the diagram shows it is 250 ohms i can not find the part no where does anyone have any ideas or is there another way to do it i checked radio shack, home depot, lowes, best buy noone has anything near that ohms that i need it has a red yellow black brown stripe on it with a lead on each side of it
mikemathis18 is offline   Reply With Quote
Unread 05-17-2010, 03:22 PM   #8
Cartsunlimited.net
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 64,079
Default Re: 1996 cc wont move

Go to a the sponsor page and pick one near you. Ask for part # 20524 for 36v or #20522 for 48v Do you have the diode?
scottyb is offline   Reply With Quote
Unread 05-17-2010, 04:30 PM   #9
Not Yet Wild
Club Car
 
Join Date: Apr 2010
Location: dinwiddie va
Posts: 20
Default Re: 1996 cc wont move

yes sir but i might as well replace it. everything else is new hopefully sfter all said and done it will be a great golf cart
mikemathis18 is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
Help on a 1996 EZ GO DCS, wont operate Electric EZGO
1996 club car will not move Electric Club Car
1996 club car will not move Electric Club Car
1996 txt clicks but wont go Electric EZGO
93 36V cart wont move Electric Club Car


All times are GMT -5. The time now is 03:50 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.