OBC question

Speck · 05-23-2010, 02:26 PM

I read process for resetting OBC for '97 CC. Would this same process work for '08 CC precedent i2?

scubabud · 05-23-2010, 03:12 PM

This is basically out of the 2006-2007 Precedent manual for rebooting the OBC:

Make sure you place the Tow/Run switch in Tow before doing anything!
Disconnect the Negative battery cable from the Main Negative lead.
Disconnect the Positive battery cable from the Main Positive lead.
Wait at least 90 seconds for the capacitors in the speed controller to discharge. The capacitors in the speed controller must be fully discharged in order to reboot the OBC.
You should be done after these 90 seconds have passed.

When completed do the following:

Make sure you still have the Tow/Run Switch in Tow.
Connect the battery cables, positive (+) cable first, then negative (-) second.
Tighten battery terminals to 110 in-lb (12.4 N•m) and coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305) to minimize corrosion.
Place Tow/Run switch in the RUN position.
Test drive the vehicle.

05-23-2010, 02:26 PM	#1
Speck Not Yet Wild Join Date: May 2010 Posts: 3	OBC question I read process for resetting OBC for '97 CC. Would this same process work for '08 CC precedent i2?
Speck Not Yet Wild Join Date: May 2010 Posts: 3

05-23-2010, 03:12 PM	#2
scubabud Ban Puppy Mills & Stores! Join Date: Dec 2008 Location: SE Florida Posts: 2,955	Re: OBC question This is basically out of the 2006-2007 Precedent manual for rebooting the OBC: Make sure you place the Tow/Run switch in Tow before doing anything! Disconnect the Negative battery cable from the Main Negative lead. Disconnect the Positive battery cable from the Main Positive lead. Wait at least 90 seconds for the capacitors in the speed controller to discharge. The capacitors in the speed controller must be fully discharged in order to reboot the OBC. You should be done after these 90 seconds have passed. When completed do the following: Make sure you still have the Tow/Run Switch in Tow. Connect the battery cables, positive (+) cable first, then negative (-) second. Tighten battery terminals to 110 in-lb (12.4 N•m) and coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305) to minimize corrosion. Place Tow/Run switch in the RUN position. Test drive the vehicle.

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum