|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
05-28-2010, 10:39 AM | #1 |
Not Yet Wild
Join Date: May 2007
Location: Chesterfield, VA
Posts: 48
|
HD solonoid/controller question
I recently tried to upgrade my solonoid on my 03 clubcar with and 18hp D&D motor and a 500 apm alltrax controller. When i went to drive it, i heard some quiet popping and after looking at things again i saw a black dust on the controller coming out of the holes as if it was smoking. 2 questions here, i think i fried my controller somehow by incorrectly hooking up the HD solonoid. Is it possible to have this fixed or will i need to purchase a new one? Also, I am looking for the least expensive route to get my cart running again even if performance has to be sacrificed. I don't have my original controller but should i buy a used stock controller just to get going again? Any thoughts??
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-28-2010, 01:10 PM | #2 |
Gone Wild
Join Date: Mar 2009
Location: South Texas
Posts: 2,391
|
Re: HD solonoid/controller question
When you installed your new HD solenoid did you replace with new the Diode unit and the proper resistor and installed them correctly? Then I would next check with D&D motors to be sure that new motor was wired correctly and any help they can give you. Then I would get on the phone to the wonderful Alltrax people about what you should do in case you had one of the ( one in a million defective ) Alltrax controllers?
|
|
|
Similar Threads | ||||
Thread | Forum | |||
1979 G1 solonoid & starter | Gas Yamaha | |||
Curtis controller and solonoid assembly . | Golf Carts and Parts | |||
solonoid | Electric Club Car | |||
solonoid clicking,running with key off | Electric Club Car | |||
Solonoid voltage | Electric EZGO |