lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 06-03-2010, 09:29 AM   #1
Not Yet Wild
 
Join Date: Jun 2010
Posts: 5
Default 2000 CC Not closing run solenoid

I have a 2000 club car that will not run in forward or reverse. Batteries are not the problem (properly tested and good voltage.) I thought the run solenoid was bad and replaced it but that was not the problem. It is a 48v regen system, OBC ver 1.35 with the Club Car DS Regen 1999-2002 wiring. If I ground the blue/white wire on the solenoid, the cart will run through all the speeds for forward and reverse with no problem. What controls the blue/white wire to tell the solenoid to close? The OBC or the controller? Any help would be great.
hollywood is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 06-03-2010, 09:50 AM   #2
Cartsunlimited.net
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 64,077
Default Re: 2000 CC Not closing run solenoid

Welcome to bgw! Check the F&R microswitch.
scottyb is offline   Reply With Quote
Unread 06-03-2010, 09:54 AM   #3
IDK&YDE
 
wilster734's Avatar
Club Car
 
Join Date: Jan 2010
Location: TEXAS
Posts: 771
Default Re: 2000 CC Not closing run solenoid

Do what Scotty says, and in the stickys for electric club car there is a wiring diagram that might help you out too
wilster734 is offline   Reply With Quote
Unread 06-03-2010, 10:35 AM   #4
Not Yet Wild
 
Join Date: Jun 2010
Posts: 5
Default Re: 2000 CC Not closing run solenoid

There is no forward reverse micro. It's a rocker switch. I believe powerdrive plus?
hollywood is offline   Reply With Quote
Unread 06-03-2010, 05:23 PM   #5
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: 2000 CC Not closing run solenoid

what solenoid did you replace the one on outer frame rail or inner frame rail?...................................
shadowman is offline   Reply With Quote
Unread 06-03-2010, 08:44 PM   #6
Not Yet Wild
 
Join Date: Jun 2010
Posts: 5
Default Re: 2000 CC Not closing run solenoid

I replaced the one on the passenger side. I think the other one wih the heat sink coil has to do with the regen, which is clicking when you push the pedal.
hollywood is offline   Reply With Quote
Unread 06-03-2010, 09:13 PM   #7
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: 2000 CC Not closing run solenoid

the OBC just controls the the charging cycles, i would look at the wiring diagram see where those wires come from........there arn,t any micro switchs tucked up in that rocker switch? been a while since i have seen one.........................................
shadowman is offline   Reply With Quote
Unread 06-03-2010, 09:50 PM   #8
Not Yet Wild
 
Join Date: Jun 2010
Posts: 5
Default Re: 2000 CC Not closing run solenoid

The only micro is in the multi step potentiometer and it is good. The blue/white wire that is supposed to ground the run solenoid goes directly into the controller and the wire has continuity to the plug of the controller. Not looking good for the controller is it.
hollywood is offline   Reply With Quote
Unread 06-04-2010, 05:19 PM   #9
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: 2000 CC Not closing run solenoid

thats a pretty reliable controller on that cart but that dosn,t mean it didn,t go bad if everything is pointing in that direction...........................
shadowman is offline   Reply With Quote
Unread 06-06-2010, 11:13 AM   #10
Dawg Gone Wild
 
TahoeDawgZ71's Avatar
Club Car
 
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 7,989
Default Re: 2000 CC Not closing run solenoid

The positive current is hardwired to every component in the system, the OBC supplies the ground to the controller, the controller then supplies ground to the solenoid. Does the reverse buzzer work? That's a sure sign that the OBC is supplying ground to the controller. If it's not working, i'd point more in the direction of the OBC before I changed that expensive controller.
TahoeDawgZ71 is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
Thread closing Golf Carts and Parts
Drive clutch not fully closing on Workhorse Gas EZGO
2000 electric Parcar won't go in reverse; suspect a faulty solenoid???? Electric golf carts
2000 PDS Resistor Across Solenoid Terminals Electric EZGO


All times are GMT -5. The time now is 05:29 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.