lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 09-25-2010, 07:22 PM   #1
Not Yet Wild
 
Join Date: Sep 2010
Posts: 2
Exclamation 1999 CLub car w/ new controller not working

I have a 1999 Elec. CLub car w/ new used controller and its not working. I get power on two ends to the motor, but the motor is not turning, I do get a clicking w/ the solenoids thats it!

Serial No:
A9932-787868

I have replaced the main control box, close to the motor. Which ones should have power coming out? Hot on Forward and reverse.


Many thanks
theidiot is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 09-25-2010, 08:01 PM   #2
Gone Wild
 
OLD MEC's Avatar
Club Car
 
Join Date: Mar 2009
Location: South Texas
Posts: 2,391
Default Re: 1999 CLub car w/ new controller not working

Need complete serial number from under passenger glove box. Was old controller working before change over and could it be new-used unit is defective? If solenoid clicks each time pedal is pressed try jumer cabel of 6 gauge or close wire across both large terminals on solenoid, BUT BEFORE TESTING DO FOLLOWING
Jack up wheels off ground, place auto type jack stands under axle round housings, block front wheels in both directions. WARNING ONLY RUN MOTOR FOR FEW SECONDS so keep from throwing pieces around when motor blows from high RPM.
What main control box are you talking about? Possibly OBC with 6 guage cable running through middle? If so only make charger work and has nothing directly to do with cart movements.
OLD MEC is offline   Reply With Quote
Unread 09-25-2010, 08:10 PM   #3
Not Yet Wild
 
Join Date: Sep 2010
Posts: 2
Exclamation Re: 1999 CLub car w/ new controller not working

We just tested, we have power coming out for reverse and forward at the same time, this means the controller is bad right?
We just jumped the motor , just like you said, but nothing happens?!

Serial NO:

A9932-787868

I think this is the electrical diagram
Attached Images
File Type: jpg Club Car.jpg (14.6 KB, 13 views)
theidiot is offline   Reply With Quote
Unread 09-25-2010, 09:00 PM   #4
Gone Wild
 
Join Date: Feb 2009
Location: Not sure yet
Posts: 500
Default Re: 1999 CLub car w/ new controller not working

If you jumped the motor and it doesnt run...motor is not good.
FIXEROFCARTS is offline   Reply With Quote
Unread 09-26-2010, 11:08 AM   #5
Gone Wild
 
OLD MEC's Avatar
Club Car
 
Join Date: Mar 2009
Location: South Texas
Posts: 2,391
Default Re: 1999 CLub car w/ new controller not working

By the diagram you indicated means you have a Power Drive Plus Regen 2 cart, so are you sure you jumped the correct solenoid? If you jump the solenoid with resistor wire coil its the wrong one, try the other one, and yes like FIXEROFCARTS says IF you jumped correct solenoid then motor is bad?
OLD MEC is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
94 club car quit working Electric Club Car
2001 club car ds not working (48V) non-IQ Electric Club Car
Club Car Charger Not Working Electric Club Car
HELP - New Controller Not Working Right Electric Club Car
1999 DS program controller Electric Club Car


All times are GMT -5. The time now is 02:18 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.