|10-26-2010, 08:36 PM||#1|
Not Yet Wild
Join Date: Jun 2008
OBC Installation Instructions
Do anyone have instructions on installing a new on board computer on a Club Car? I bought a new OBC but it didn't come with instructions.
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
|10-26-2010, 08:56 PM||#2|
Join Date: Nov 2008
Location: Peachtree City, Georgia
Re: OBC Installation Instructions
1. disconnect the battery pack at the negative side.
2. Running from the back of the cart to where the OBC is to the charging receptacle is a gray wire loom, that's part of the OBC, disconnect the yellow fuse holder, and use a 3/8" socket to remove the nut holding the black wire to the charging receptacle.
3. Remove the rear plastic cover that covers the motor and the controller, from the back of the cart, the OBC will be on the fire wall (so to speak) on the left side. There will be a weather tight connector that needs to unplugged. The negative battery cable as well as the negative lead for the OBC will be tied together on the B- port of the controller, you'll most likely need two 1/2" wrenches to remove the nut and bolt holding it to the controller.
4. Then on the OBC itself there is a 3/8" bolt on the very top of the OBC, which is hard to see and one on the bottom, these simply need to be backed out a bit but not removed and then the OBC will slide to the left and slip off the screws.
Installation is reverse of what you just did.
|EZGO Freedom Light Kit Installation Instructions||Electric EZGO|
|I need backseat installation instructions for club car||Electric Club Car|
|wanted instructions||Golf Carts and Parts|
|motor instructions||Gas Club Car|
|Yamaha Torque Kit Instructions||Gas Yamaha|